[PATCH v4 0/4] mtd:nand:omap2: clean-up of supported ECC schemes

[Gupta, Pekon]

> 
> On Wednesday 03 July 2013, Artem Bityutskiy wrote:
> > On Wed, 2013-07-03 at 13:16 +0000, Gupta, Pekon wrote:
> > > [Pekon]: Yes, I'm not seeing these build issues, as I'm cleanly
> > > returning from probe with pr_err(), if the required libraries (/lib/bch.c)
> > > are not build-in the system.
> > > -------------------
> > > [Patch v4 1/4]: mtd:nand:omap2: clean-up BCHx_HW and BCHx_SW ECC..
> > > @@static int omap_nand_probe(struct platform_device *pdev)
> > > +	default:
> > > +		pr_err("selected ECC scheme not supported or not
> enabled\n");
> > > +		err = -EINVAL;
> > > +		goto out_release_mem_region;
> > > +	}
> > > -------------------
> > > However, if you are still seeing this, could you please send me your
> config?
> >
> > I compile tested your patches too, and did not see any issues with my
> > omap2_defconfig.
> 
> 
> To clarify: I'm getting this error with randconfig on today's linux-next.
> I think it only happens with MTD_NAND_ECC_BCH enabled, which is not
> the default in omap2_defconfig.
> 
> 	Arnd

Hi Arnd, Artem, Stephen,

I see the issue in linux-next/master tree..
linux-next/master has only the first [Patch v4 1/4] from the series.
Other patches [Patch v4 2/4.. 4/4] of this series were dropped,
as 'Olof Johansson' had some apprehensions about DT bindings.
http://permalink.gmane.org/gmane.linux.ports.arm.kernel/249662

As these patches are inter-dependent, so please drop the whole series
including the commit below.
fb1585b  [Patch v4 1/4] mtd: nand: omap2: clean-up BCHx_HW and BCHx_SW

I'm awaiting feedbacks from 'Olof Johansson' or other DT maintainers,
once approved, I'll resend the whole series.

"[PATCH v4 2/4] ARM: OMAP2+: cleaned-up DT support " had the
declarations which were required for above build errors.
---------------
include/linux/platform_data/mtd-nand-omap2.h
enum omap_ecc {
+	/* 4-bit  ECC calculation by GPMC, Error detection by Software */
+	OMAP_ECC_BCH4_CODE_HW_DETECTION_SW,
...
+	/* 8-bit  ECC calculation by GPMC, Error detection by Software */
+	OMAP_ECC_BCH8_CODE_HW_DETECTION_SW
---------------


with regards, pekon