[PATCH 2/3] drivers: spi: Add qspi flash controller

[Mark Brown]

On Wed, Jun 26, 2013 at 01:11:11PM +0530, Sourav Poddar wrote:

> +static int dra7xxx_qspi_prepare_xfer(struct spi_master *master)
> +{
> +	return 0;
> +}
> +
> +static int dra7xxx_qspi_unprepare_xfer(struct spi_master *master)
> +{
> +	return 0;
> +}

Remove empty functions, though...

> +	if (flags & XFER_END)
> +		dra7xxx_writel(qspi, qspi->cmd | QSPI_INVAL, QSPI_SPI_CMD_REG);
> +
> +	pm_runtime_mark_last_busy(qspi->dev);
> +	pm_runtime_put_autosuspend(qspi->dev);

...there's no point in doing this per-message, it should be in the
prepare and unprepare functions.

> +	master = spi_alloc_master(&pdev->dev, sizeof(*qspi));
> +	if (!master)
> +		return -ENOMEM;
> +
> +	master->mode_bits = SPI_CPOL | SPI_CPHA;
> +
> +	master->num_chipselect = 1;
> +	master->bus_num = -1;
> +	master->setup = dra7xxx_qspi_setup;
> +	master->prepare_transfer_hardware = dra7xxx_qspi_prepare_xfer;
> +	master->transfer_one_message = dra7xxx_qspi_start_transfer_one;
> +	master->unprepare_transfer_hardware = dra7xxx_qspi_unprepare_xfer;
> +	master->dev.of_node = pdev->dev.of_node;

There should be some bits per word restrictions in here I think - it
looks like only 8 bits per word is supported.

> +	qspi->base = devm_request_and_ioremap(&pdev->dev, r);
> +	if (!qspi->base) {
> +		dev_dbg(&pdev->dev, "can't ioremap MCSPI\n");
> +		ret = -ENOMEM;
> +		goto free_master;
> +	}

Use devm_ioremap_resource().

> +	if (!of_property_read_u32(np, "spi-max-frequency", &max_freq))
> +		qspi->spi_max_frequency = max_freq;

You have OF bindings, there should be a binding document and an OF ID
table.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 836 bytes
Desc: Digital signature
URL: <http://lists.infradead.org/pipermail/linux-mtd/attachments/20130701/7ee8a907/attachment.sig>