[PATCH v3 1/4] mtd:nand:omap2: clean-up BCHx_HW and BCHx_SW ECC configurations in device_probe

[Artem Bityutskiy]

Hi Pekon,

On Sun, 2013-06-23 at 23:28 +0530, Pekon Gupta wrote:
> +---------------------------------------+---------------+---------------+
> | ECC scheme				|ECC calculation|Error detection|
> +---------------------------------------+---------------+---------------+
> |OMAP_ECC_HAMMING_CODE_DEFAULT		|S/W		|S/W		|
> |OMAP_ECC_HAMMING_CODE_HW		|H/W (GPMC)	|S/W		|
> |OMAP_ECC_HAMMING_CODE_HW_ROMCODE	|H/W (GPMC)	|S/W		|
> +---------------------------------------+---------------+---------------+
> |(requires CONFIG_MTD_NAND_ECC_BCH)	|		|		|
> |OMAP_ECC_BCH8_CODE_HW_DETECTION_SW	|H/W (GPMC)	|S/W		|
> +---------------------------------------+---------------+---------------+
> |(requires CONFIG_MTD_NAND_OMAP_BCH)	|		|		|
> |OMAP_ECC_BCH8_CODE_HW			|H/W (GPMC)	|H/W (ELM)	|
> +---------------------------------------+---------------+---------------+

This is a nice table, and you are doing very good job clearly
classifying what is going on. I'd suggest to also put stuff like this to
comments in the code.

> This patch
> - separates the configurations for various ECC schemes.
> - fixes dependency issues based on Kconfig options.
> - cleans up redundant code
> 
> Signed-off-by: Pekon Gupta <pekon at ti.com>

This does not apply to l2-mtd.git, could you please re-base?

-- 
Best Regards,
Artem Bityutskiy