[PATCH V2 1/4] mtd: atmel_nand: use dev_err() instead of printk()

[Jingoo Han]

Use dev_err() instead of printk() to provide a better message
to userspace.

Signed-off-by: Jingoo Han <jg1.han at samsung.com>
---
Change since v1
- Remove the site-specific OOM messages.

 drivers/mtd/nand/atmel_nand.c |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index e633c44..c36e9b8 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -2060,14 +2060,14 @@ static int atmel_nand_probe(struct platform_device *pdev)
 		}
 
 		if (gpio_get_value(host->board.det_pin)) {
-			printk(KERN_INFO "No SmartMedia card inserted.\n");
+			dev_info(&pdev->dev, "No SmartMedia card inserted.\n");
 			res = -ENXIO;
 			goto err_no_card;
 		}
 	}
 
 	if (host->board.on_flash_bbt || on_flash_bbt) {
-		printk(KERN_INFO "atmel_nand: Use On Flash BBT\n");
+		dev_info(&pdev->dev, "Use On Flash BBT\n");
 		nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
 	}
 
-- 
1.7.10.4