OMAP3 NAND ECC selection

[Mike Dunn]

On 12/05/2013 11:38 AM, Tony Lindgren wrote:
> * Thomas Petazzoni <thomas.petazzoni at free-electrons.com> [131205 11:33]:
>> Dear Brian Norris,
>>
>> On Thu, 5 Dec 2013 11:24:18 -0800, Brian Norris wrote:
>>
>>>> The long term benefits is simply to properly handle the hardware
>>>> constraints. We have hardware platforms were parts of the NAND *MUST*
>>>> use 1-bit ECC to be compatible with the ROM code, and other parts of
>>>> the NAND *MUST* use stronger 4-bits or 8-bits ECC to comply with the
>>>> NAND requirements.
>>>
>>> Using 1-bit ECC on NAND is not a long-term solution. Given that fact,
>>> I think your ROM code is what may need to change, not the entire MTD
>>> subsystem.
>>
>> As someone (Tom Rini maybe?) pointed out, today the shift is 1-bit ECC
>> supported by ROM code vs. 4 or 8 bits required by NAND. But we can very
>> well imagine that tomorrow ROM code will support BCH4 (and the NAND
>> will ensure block 0 is OK for use with BCH4) but the rest of the NAND
>> will require BCH16 or something like that.
>>
>> I'm not designing ROM code, and the fact that they today have this
>> limitation, should be an indication that Linux should be capable of
>> handling different ECC schemes to handle those hardware constraints.
> 
> Yeah and it seems that for the bootloader partition we need to be able
> to specify the ECC scheme in the .dts file to avoid having people trash
> their system unless they really want to do it.
> 
> /me at least has rebooted and reflashed way too many times unnecessarily
> while trying to update MLO or u-boot from the kernel.


The M-Sys/Sandisk docg4 flash chip has a similiar issue, but is even more
esoteric than merely a different ecc scheme for the SPL/u-boot partition.  Not
only is a different ecc scheme used for the SPL (actually it uses no ecc at
all), but the flash controller must be placed into a special (proprietary) mode
("reliable mode") before the SPL is written.  Like the omap2 solution, the docg4
driver can be loaded with a special module parameter that enables writing the
SPL partition in this mode.

The docg4 is kind of a special case, though, because it is a nand flash wrapped
inside a proprietary non-standard flash controller.

Mike