[PATCH v4 03/14] mtd: nand: pxa3xx: Handle ECC and DMA enable/disable properly

[Ezequiel Garcia]

When ECC is not selected, the ECC enable bit must be cleared
in the NAND control register. Same applies to DMA.

Signed-off-by: Ezequiel Garcia <ezequiel.garcia at free-electrons.com>
Tested-by: Daniel Mack <zonque at gmail.com>
---
 drivers/mtd/nand/pxa3xx_nand.c | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/pxa3xx_nand.c b/drivers/mtd/nand/pxa3xx_nand.c
index 55eb153..dfff327 100644
--- a/drivers/mtd/nand/pxa3xx_nand.c
+++ b/drivers/mtd/nand/pxa3xx_nand.c
@@ -314,8 +314,17 @@ static void pxa3xx_nand_start(struct pxa3xx_nand_info *info)
 	uint32_t ndcr;
 
 	ndcr = host->reg_ndcr;
-	ndcr |= info->use_ecc ? NDCR_ECC_EN : 0;
-	ndcr |= info->use_dma ? NDCR_DMA_EN : 0;
+
+	if (info->use_ecc)
+		ndcr |= NDCR_ECC_EN;
+	else
+		ndcr &= ~NDCR_ECC_EN;
+
+	if (info->use_dma)
+		ndcr |= NDCR_DMA_EN;
+	else
+		ndcr &= ~NDCR_DMA_EN;
+
 	ndcr |= NDCR_ND_RUN;
 
 	/* clear status bits and run */
-- 
1.8.1.5