[PATCH 07/11] fsmc/nand: Provide contiguous buffers to dma

Vipin Kumar vipin.kumar at st.com
Thu Oct 11 00:07:16 EDT 2012


On 10/11/2012 8:46 AM, viresh kumar wrote:
> On Wed, Oct 10, 2012 at 10:37 PM, Linus Walleij
> <linus.walleij at linaro.org>  wrote:
>> The real problem is likely the DMA driver. The stuf that get
>> fed into dma.device_prep_dma_memcpy() needs to be
>> converted to a scatterlist and then set up in the LLI list
>> for the controller.
>>
>> IIRC SPEAr is using drivers/dma/dw_dmac.c so
>
> Both dw_dmac and pl080 for different SPEAr SoC's.
>
>> check this driver's dwc_prep_dma_memcpy().
>> It does seem like it is checking whether src or
>> dest is scattered in this for() loop:
>>
>> for (offset = 0; offset<  len; offset += xfer_count<<  src_width) {}
>>
>> dma_sync_single_for_device() is translating the virtual
>> address to physical for every chunk BTW.
>>
>> So instead of doing this copying, debug the problem, and
>> see if there is a bug in that for()-loop or similar, if it needs
>> to be rewritten or so.
>
> But what's the problem you saw vipin, for which you generated this patch?
> .
>

The nand tests were failing and that was because of a user pointer being 
passed to them but it was a long time back and this patch just carried 
on in the local repo. It is only now that I am sending it

It seems may be the dma drivers also got updated so it needs another 
test cycle it. I will do the needful and re-reply back on this mail

Vipin




More information about the linux-mtd mailing list