[PATCH] driver/mtd/IFC:Wait tWB time, poll R/B before command execution

Prabhakar Kushwaha prabhakar at freescale.com
Thu Nov 8 03:12:59 EST 2012


IFC_FIR_OP_CMD0 issues command for execution without checking flash
readiness. It may cause problem if flash is not ready. Instead use
IFC_FIR_OP_CW0 which Wait for tWB time and poll R/B to return high or
time-out, before issuing command.

NAND_CMD_READID command implemention does not fulfill above requirement. So
update its programming.

Signed-off-by: Prabhakar Kushwaha <prabhakar at freescale.com>
Signed-off-by: Hemant Nautiyal <hemant.nautiyal at freescale.com>
---
 Based upon git://git.infradead.org/linux-mtd.git branch master

 drivers/mtd/nand/fsl_ifc_nand.c |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/fsl_ifc_nand.c b/drivers/mtd/nand/fsl_ifc_nand.c
index 8f0dd13..7e5b17c 100644
--- a/drivers/mtd/nand/fsl_ifc_nand.c
+++ b/drivers/mtd/nand/fsl_ifc_nand.c
@@ -382,7 +382,7 @@ static void fsl_ifc_cmdfunc(struct mtd_info *mtd, unsigned int command,
 			timing = IFC_FIR_OP_RBCD;
 
 		out_be32(&ifc->ifc_nand.nand_fir0,
-				(IFC_FIR_OP_CMD0 << IFC_NAND_FIR0_OP0_SHIFT) |
+				(IFC_FIR_OP_CW0 << IFC_NAND_FIR0_OP0_SHIFT) |
 				(IFC_FIR_OP_UA  << IFC_NAND_FIR0_OP1_SHIFT) |
 				(timing << IFC_NAND_FIR0_OP2_SHIFT));
 		out_be32(&ifc->ifc_nand.nand_fcr0,
@@ -785,7 +785,7 @@ static void fsl_ifc_sram_init(struct fsl_ifc_mtd *priv)
 
 	/* READID */
 	out_be32(&ifc->ifc_nand.nand_fir0,
-			(IFC_FIR_OP_CMD0 << IFC_NAND_FIR0_OP0_SHIFT) |
+			(IFC_FIR_OP_CW0 << IFC_NAND_FIR0_OP0_SHIFT) |
 			(IFC_FIR_OP_UA  << IFC_NAND_FIR0_OP1_SHIFT) |
 			(IFC_FIR_OP_RB << IFC_NAND_FIR0_OP2_SHIFT));
 	out_be32(&ifc->ifc_nand.nand_fcr0,
-- 
1.7.9.5






More information about the linux-mtd mailing list