[PATCH v8 1/3] MTD: at91: extract hw ecc initialization to one function
Josh Wu
josh.wu at atmel.com
Wed May 23 03:47:52 EDT 2012
Signed-off-by: Hong Xu <hong.xu at atmel.com>
Signed-off-by: Josh Wu <josh.wu at atmel.com>
---
drivers/mtd/nand/atmel_nand.c | 147 ++++++++++++++++++++-----------------
drivers/mtd/nand/atmel_nand_ecc.h | 8 +-
2 files changed, 85 insertions(+), 70 deletions(-)
diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 2165576..9723702 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -42,20 +42,15 @@
#include <mach/cpu.h>
+/* Hardware ECC registers */
+#include "atmel_nand_ecc.h"
+
static int use_dma = 1;
module_param(use_dma, int, 0);
static int on_flash_bbt = 0;
module_param(on_flash_bbt, int, 0);
-/* Register access macros */
-#define ecc_readl(add, reg) \
- __raw_readl(add + ATMEL_ECC_##reg)
-#define ecc_writel(add, reg, value) \
- __raw_writel((value), add + ATMEL_ECC_##reg)
-
-#include "atmel_nand_ecc.h" /* Hardware ECC registers */
-
/* oob layout for large page size
* bad block info is on bytes 0 and 1
* the bytes have to be consecutives to avoid
@@ -523,6 +518,75 @@ static int __devinit atmel_of_init_port(struct atmel_nand_host *host,
}
#endif
+static int __init atmel_hw_nand_init_params(struct platform_device *pdev,
+ struct atmel_nand_host *host)
+{
+ struct resource *regs;
+ struct mtd_info *mtd;
+ struct nand_chip *nand_chip;
+
+ nand_chip = &host->nand_chip;
+ mtd = &host->mtd;
+
+ nand_chip->ecc.mode = NAND_ECC_SOFT;
+ regs = platform_get_resource(pdev, IORESOURCE_MEM, 1);
+ if (!regs) {
+ dev_err(host->dev,
+ "Can't get I/O resource regs, use software ECC\n");
+ } else {
+ host->ecc = ioremap(regs->start, resource_size(regs));
+ if (host->ecc == NULL) {
+ printk(KERN_ERR "atmel_nand: ioremap failed\n");
+ return -EIO;
+ }
+
+ nand_chip->ecc.mode = NAND_ECC_HW;
+ nand_chip->ecc.calculate = atmel_nand_calculate;
+ nand_chip->ecc.correct = atmel_nand_correct;
+ nand_chip->ecc.hwctl = atmel_nand_hwctl;
+ nand_chip->ecc.read_page = atmel_nand_read_page;
+ nand_chip->ecc.bytes = 4;
+ nand_chip->ecc.strength = 1;
+
+ /* ECC is calculated for the whole page (1 step) */
+ nand_chip->ecc.size = mtd->writesize;
+
+ /* set ECC page size and oob layout */
+ switch (mtd->writesize) {
+ case 512:
+ nand_chip->ecc.layout = &atmel_oobinfo_small;
+ ecc_writel(host->ecc, MR, ATMEL_ECC_PAGESIZE_528);
+ break;
+ case 1024:
+ nand_chip->ecc.layout = &atmel_oobinfo_large;
+ ecc_writel(host->ecc, MR, ATMEL_ECC_PAGESIZE_1056);
+ break;
+ case 2048:
+ nand_chip->ecc.layout = &atmel_oobinfo_large;
+ ecc_writel(host->ecc, MR, ATMEL_ECC_PAGESIZE_2112);
+ break;
+ case 4096:
+ nand_chip->ecc.layout = &atmel_oobinfo_large;
+ ecc_writel(host->ecc, MR, ATMEL_ECC_PAGESIZE_4224);
+ break;
+ default:
+ /* page size not handled by HW ECC */
+ /* switching back to soft ECC */
+ nand_chip->ecc.mode = NAND_ECC_SOFT;
+ nand_chip->ecc.calculate = NULL;
+ nand_chip->ecc.correct = NULL;
+ nand_chip->ecc.hwctl = NULL;
+ nand_chip->ecc.read_page = NULL;
+ nand_chip->ecc.postpad = 0;
+ nand_chip->ecc.prepad = 0;
+ nand_chip->ecc.bytes = 0;
+ break;
+ }
+ }
+
+ return 0;
+}
+
/*
* Probe for the NAND device.
*/
@@ -531,7 +595,6 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
struct atmel_nand_host *host;
struct mtd_info *mtd;
struct nand_chip *nand_chip;
- struct resource *regs;
struct resource *mem;
struct mtd_part_parser_data ppdata = {};
int res;
@@ -583,29 +646,6 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
nand_chip->dev_ready = atmel_nand_device_ready;
nand_chip->ecc.mode = host->board.ecc_mode;
-
- regs = platform_get_resource(pdev, IORESOURCE_MEM, 1);
- if (!regs && nand_chip->ecc.mode == NAND_ECC_HW) {
- printk(KERN_ERR "atmel_nand: can't get I/O resource "
- "regs\nFalling back on software ECC\n");
- nand_chip->ecc.mode = NAND_ECC_SOFT;
- }
-
- if (nand_chip->ecc.mode == NAND_ECC_HW) {
- host->ecc = ioremap(regs->start, resource_size(regs));
- if (host->ecc == NULL) {
- printk(KERN_ERR "atmel_nand: ioremap failed\n");
- res = -EIO;
- goto err_ecc_ioremap;
- }
- nand_chip->ecc.calculate = atmel_nand_calculate;
- nand_chip->ecc.correct = atmel_nand_correct;
- nand_chip->ecc.hwctl = atmel_nand_hwctl;
- nand_chip->ecc.read_page = atmel_nand_read_page;
- nand_chip->ecc.bytes = 4;
- nand_chip->ecc.strength = 1;
- }
-
nand_chip->chip_delay = 20; /* 20us command delay time */
if (host->board.bus_width_16) /* 16-bit bus width */
@@ -657,40 +697,9 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
}
if (nand_chip->ecc.mode == NAND_ECC_HW) {
- /* ECC is calculated for the whole page (1 step) */
- nand_chip->ecc.size = mtd->writesize;
-
- /* set ECC page size and oob layout */
- switch (mtd->writesize) {
- case 512:
- nand_chip->ecc.layout = &atmel_oobinfo_small;
- ecc_writel(host->ecc, MR, ATMEL_ECC_PAGESIZE_528);
- break;
- case 1024:
- nand_chip->ecc.layout = &atmel_oobinfo_large;
- ecc_writel(host->ecc, MR, ATMEL_ECC_PAGESIZE_1056);
- break;
- case 2048:
- nand_chip->ecc.layout = &atmel_oobinfo_large;
- ecc_writel(host->ecc, MR, ATMEL_ECC_PAGESIZE_2112);
- break;
- case 4096:
- nand_chip->ecc.layout = &atmel_oobinfo_large;
- ecc_writel(host->ecc, MR, ATMEL_ECC_PAGESIZE_4224);
- break;
- default:
- /* page size not handled by HW ECC */
- /* switching back to soft ECC */
- nand_chip->ecc.mode = NAND_ECC_SOFT;
- nand_chip->ecc.calculate = NULL;
- nand_chip->ecc.correct = NULL;
- nand_chip->ecc.hwctl = NULL;
- nand_chip->ecc.read_page = NULL;
- nand_chip->ecc.postpad = 0;
- nand_chip->ecc.prepad = 0;
- nand_chip->ecc.bytes = 0;
- break;
- }
+ res = atmel_hw_nand_init_params(pdev, host);
+ if (res != 0)
+ goto err_hw_ecc;
}
/* second phase scan */
@@ -707,15 +716,15 @@ static int __init atmel_nand_probe(struct platform_device *pdev)
return res;
err_scan_tail:
+ if (host->ecc)
+ iounmap(host->ecc);
+err_hw_ecc:
err_scan_ident:
err_no_card:
atmel_nand_disable(host);
platform_set_drvdata(pdev, NULL);
if (host->dma_chan)
dma_release_channel(host->dma_chan);
- if (host->ecc)
- iounmap(host->ecc);
-err_ecc_ioremap:
iounmap(host->io_base);
err_nand_ioremap:
kfree(host);
diff --git a/drivers/mtd/nand/atmel_nand_ecc.h b/drivers/mtd/nand/atmel_nand_ecc.h
index 578c776..b437567 100644
--- a/drivers/mtd/nand/atmel_nand_ecc.h
+++ b/drivers/mtd/nand/atmel_nand_ecc.h
@@ -3,7 +3,7 @@
* Based on AT91SAM9260 datasheet revision B.
*
* Copyright (C) 2007 Andrew Victor
- * Copyright (C) 2007 Atmel Corporation.
+ * Copyright (C) 2007 - 2012 Atmel Corporation.
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of the GNU General Public License as published by the
@@ -36,4 +36,10 @@
#define ATMEL_ECC_NPR 0x10 /* NParity register */
#define ATMEL_ECC_NPARITY (0xffff << 0) /* NParity */
+/* Register Access Macros */
+#define ecc_readl(add, reg) \
+ __raw_readl(add + ATMEL_ECC_##reg)
+#define ecc_writel(add, reg, value) \
+ __raw_writel((value), add + ATMEL_ECC_##reg)
+
#endif
--
1.7.10
More information about the linux-mtd
mailing list