[PATCH] mtd: gpio-nand: add device tree bindings

Jamie Iles jamie at jamieiles.com
Wed Jul 27 10:03:30 EDT 2011


Add device tree bindings so that the gpio-nand driver may be
instantiated from the device tree.  This also allows the partitions
to be specified in the device tree.

Cc: David Woodhouse <dwmw2 at infradead.org>
Cc: Artem Bityutskiy <Artem.Bityutskiy at nokia.com>
Signed-off-by: Jamie Iles <jamie at jamieiles.com>
---

I have this working on our platform using the following DT section:

	ebi {
		compatible = "simple-bus";
		#address-cells = <2>;
		#size-cells = <1>;
		ranges = <0 0 0x40000000 0x08000000
			  1 0 0x48000000 0x08000000
			  2 0 0x50000000 0x08000000
			  3 0 0x58000000 0x08000000>;

		nand: gpio-nand at 2,0 {
			compatible = "gpio-nand";
			#address-cells = <0>;
			#size-cells = <0>;
			reg = <2 0x0000 0x1000
			       0 0x2000 0x0004>;

			gpios = <&banka 1 0	/* rdy */
				 &banka 2 0 	/* nce */
				 &banka 3 0 	/* ale */
				 &banka 4 0 	/* cle */
				 0		/* nwp */>;

			boot at 100000 {
				label = "Boot";
				reg = <0x100000 0x80000>;
			};

			...
		};
	};
};

but to provide synchronisation with regards to the bus reordering, we actually
need to perform a read from the GPIO controller rather than the EBI, but I'm
not sure how to express this in the DT when using ranges like this, so any
suggestions would be welcome!

Jamie

 .../devicetree/bindings/mtd/gpio-nand.txt          |   43 +++++++++
 drivers/mtd/nand/gpio.c                            |   91 ++++++++++++++++++--
 2 files changed, 126 insertions(+), 8 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/mtd/gpio-nand.txt

diff --git a/Documentation/devicetree/bindings/mtd/gpio-nand.txt b/Documentation/devicetree/bindings/mtd/gpio-nand.txt
new file mode 100644
index 0000000..98cb152
--- /dev/null
+++ b/Documentation/devicetree/bindings/mtd/gpio-nand.txt
@@ -0,0 +1,43 @@
+GPIO assisted NAND flash
+
+Required properties:
+- compatible : "gpio-nand"
+- reg : should specify localbus chip select and size used for the chip.  For
+  ARM platforms where a dummy read is needed to provide synchronisation with
+  regards to bus reordering, an optional second resource describes the
+  location to read from.
+- #address-cells, #size-cells : Must be present if the device has sub-nodes
+  representing partitions.  In this case, both #address-cells and #size-cells
+  must be equal to 1.
+- gpios : specifies the gpio pins to control the NAND device.  nwp is an
+  optional gpio and may be set to 0 if not present.
+
+Optional properties:
+- bank-width : Width (in bytes) of the bank.  Equal to the device width times
+  the number of interleaved chips.
+- chip-delay : chip dependent delay for transferring data from array to
+  read registers (tR).
+
+Examples:
+
+gpio-nand at 1,0 {
+	compatible = "gpio-nand";
+	reg = <1 0x0000 0x1000>;
+	#address-cells = <1>;
+	#size-cells = <1>;
+	gpios = <&banka 1 0	/* rdy */
+		 &banka 2 0 	/* nce */
+		 &banka 3 0 	/* ale */
+		 &banka 4 0 	/* cle */
+		 0		/* nwp */>;
+
+	flash {
+		#address-cells = <1>;
+		#size-cells = <1>;
+		compatible = "...";
+
+		partition at 0 {
+			...
+		};
+	};
+};
diff --git a/drivers/mtd/nand/gpio.c b/drivers/mtd/nand/gpio.c
index 2c2060b..ee74593 100644
--- a/drivers/mtd/nand/gpio.c
+++ b/drivers/mtd/nand/gpio.c
@@ -27,6 +27,9 @@
 #include <linux/mtd/nand.h>
 #include <linux/mtd/partitions.h>
 #include <linux/mtd/nand-gpio.h>
+#include <linux/of.h>
+#include <linux/of_address.h>
+#include <linux/of_gpio.h>
 
 struct gpiomtd {
 	void __iomem		*io_sync;
@@ -221,14 +224,70 @@ static void __iomem *request_and_remap(struct resource *res, size_t size,
 	return ptr;
 }
 
+static const struct of_device_id gpio_nand_id_table[] = {
+	{ .compatible = "gpio-nand" },
+	{}
+};
+MODULE_DEVICE_TABLE(of, gpio_nand_id_table);
+
+static int gpio_nand_of_get_options(struct device *dev,
+				    struct gpio_nand_platdata *plat)
+{
+	u32 width;
+
+	if (!of_property_read_u32(dev->of_node, "bank-width", &width)) {
+		if (width == 2) {
+			plat->options |= NAND_BUSWIDTH_16;
+		} else if (width != 1) {
+			dev_err(dev, "invalid bank-width %u\n", width);
+			return -EINVAL;
+		}
+	}
+
+	return 0;
+}
+
+static void gpio_nand_of_get_gpio(struct device *dev,
+				  struct gpio_nand_platdata *plat)
+{
+	plat->gpio_rdy = of_get_gpio(dev->of_node, 0);
+	plat->gpio_nce = of_get_gpio(dev->of_node, 1);
+	plat->gpio_ale = of_get_gpio(dev->of_node, 2);
+	plat->gpio_cle = of_get_gpio(dev->of_node, 3);
+	plat->gpio_nwp = of_get_gpio(dev->of_node, 4);
+}
+
+static void gpio_nand_of_get_chip_delay(struct device *dev,
+					struct gpio_nand_platdata *plat)
+{
+	u32 chip_delay;
+
+	if (!of_property_read_u32(dev->of_node, "chip-delay", &chip_delay))
+		plat->chip_delay = (int)chip_delay;
+}
+
+static int gpio_nand_of_get_config(struct device *dev,
+				   struct gpio_nand_platdata *plat)
+{
+	int ret = gpio_nand_of_get_options(dev, plat);
+
+	if (ret < 0)
+		return ret;
+
+	gpio_nand_of_get_gpio(dev, plat);
+	gpio_nand_of_get_chip_delay(dev, plat);
+
+	return 0;
+}
+
 static int __devinit gpio_nand_probe(struct platform_device *dev)
 {
 	struct gpiomtd *gpiomtd;
 	struct nand_chip *this;
 	struct resource *res0, *res1;
-	int ret;
+	int ret = 0;
 
-	if (!dev->dev.platform_data)
+	if (!dev->dev.of_node && !dev->dev.platform_data)
 		return -EINVAL;
 
 	res0 = platform_get_resource(dev, IORESOURCE_MEM, 0);
@@ -257,11 +316,17 @@ static int __devinit gpio_nand_probe(struct platform_device *dev)
 		}
 	}
 
-	memcpy(&gpiomtd->plat, dev->dev.platform_data, sizeof(gpiomtd->plat));
+	if (dev->dev.platform_data)
+		memcpy(&gpiomtd->plat, dev->dev.platform_data,
+		       sizeof(gpiomtd->plat));
+	else
+		ret = gpio_nand_of_get_config(&dev->dev, &gpiomtd->plat);
+	if (ret)
+		goto err_config;
 
 	ret = gpio_request(gpiomtd->plat.gpio_nce, "NAND NCE");
 	if (ret)
-		goto err_nce;
+		goto err_config;
 	gpio_direction_output(gpiomtd->plat.gpio_nce, 1);
 	if (gpio_is_valid(gpiomtd->plat.gpio_nwp)) {
 		ret = gpio_request(gpiomtd->plat.gpio_nwp, "NAND NWP");
@@ -312,12 +377,21 @@ static int __devinit gpio_nand_probe(struct platform_device *dev)
 		goto err_wp;
 	}
 
-	if (gpiomtd->plat.adjust_parts)
-		gpiomtd->plat.adjust_parts(&gpiomtd->plat,
-					   gpiomtd->mtd_info.size);
+	if (dev->dev.platform_data) {
+		if (gpiomtd->plat.adjust_parts)
+			gpiomtd->plat.adjust_parts(&gpiomtd->plat,
+						   gpiomtd->mtd_info.size);
+	} else {
+		ret = of_mtd_parse_partitions(&dev->dev, dev->dev.of_node,
+					      &gpiomtd->plat.parts);
+		if (ret < 0)
+			goto err_wp;
 
+		gpiomtd->plat.num_parts = (unsigned int)ret;
+	}
 	mtd_device_register(&gpiomtd->mtd_info, gpiomtd->plat.parts,
 			    gpiomtd->plat.num_parts);
+
 	platform_set_drvdata(dev, gpiomtd);
 
 	return 0;
@@ -335,7 +409,7 @@ err_ale:
 		gpio_free(gpiomtd->plat.gpio_nwp);
 err_nwp:
 	gpio_free(gpiomtd->plat.gpio_nce);
-err_nce:
+err_config:
 	iounmap(gpiomtd->io_sync);
 	if (res1)
 		release_mem_region(res1->start, resource_size(res1));
@@ -352,6 +426,7 @@ static struct platform_driver gpio_nand_driver = {
 	.remove		= gpio_nand_remove,
 	.driver		= {
 		.name	= "gpio-nand",
+		.of_match_table = gpio_nand_id_table,
 	},
 };
 
-- 
1.7.4.1




More information about the linux-mtd mailing list