[PATCH v9 3/7] omap: gpmc: enable irq mode in gpmc
Sukumar Ghorai
s-ghorai at ti.com
Fri Jan 28 05:12:05 EST 2011
add support the irq mode in GPMC.
gpmc_init() function move after omap_init_irq() as it has dependecy on irq.
Signed-off-by: Sukumar Ghorai <s-ghorai at ti.com>
---
arch/arm/mach-omap2/gpmc.c | 45 +++++++++++++++++++++++++++++--
arch/arm/mach-omap2/io.c | 2 -
arch/arm/plat-omap/include/plat/gpmc.h | 5 +++-
arch/arm/plat-omap/include/plat/irqs.h | 9 +++++-
4 files changed, 54 insertions(+), 7 deletions(-)
diff --git a/arch/arm/mach-omap2/gpmc.c b/arch/arm/mach-omap2/gpmc.c
index 1b7b3e7..382dea8 100644
--- a/arch/arm/mach-omap2/gpmc.c
+++ b/arch/arm/mach-omap2/gpmc.c
@@ -14,6 +14,7 @@
*/
#undef DEBUG
+#include <linux/irq.h>
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/err.h>
@@ -22,6 +23,7 @@
#include <linux/spinlock.h>
#include <linux/io.h>
#include <linux/module.h>
+#include <linux/interrupt.h>
#include <asm/mach-types.h>
#include <plat/gpmc.h>
@@ -100,6 +102,8 @@ static void __iomem *gpmc_base;
static struct clk *gpmc_l3_clk;
+static irqreturn_t gpmc_handle_irq(int irq, void *dev);
+
static void gpmc_write_reg(int idx, u32 val)
{
__raw_writel(val, gpmc_base + idx);
@@ -497,6 +501,10 @@ int gpmc_cs_configure(int cs, int cmd, int wval)
u32 regval = 0;
switch (cmd) {
+ case GPMC_ENABLE_IRQ:
+ gpmc_write_reg(GPMC_IRQENABLE, wval);
+ break;
+
case GPMC_SET_IRQ_STATUS:
gpmc_write_reg(GPMC_IRQSTATUS, wval);
break;
@@ -678,9 +686,10 @@ static void __init gpmc_mem_init(void)
}
}
-void __init gpmc_init(void)
+static int __init gpmc_init(void)
{
- u32 l;
+ u32 l, irq;
+ int cs, ret = -EINVAL;
char *ck = NULL;
if (cpu_is_omap24xx()) {
@@ -698,7 +707,7 @@ void __init gpmc_init(void)
}
if (WARN_ON(!ck))
- return;
+ return ret;
gpmc_l3_clk = clk_get(NULL, ck);
if (IS_ERR(gpmc_l3_clk)) {
@@ -723,6 +732,36 @@ void __init gpmc_init(void)
l |= (0x02 << 3) | (1 << 0);
gpmc_write_reg(GPMC_SYSCONFIG, l);
gpmc_mem_init();
+
+ /* initalize the irq_chained */
+ irq = OMAP_GPMC_IRQ_BASE;
+ for (cs = 0; cs < GPMC_CS_NUM; cs++) {
+ set_irq_handler(irq, handle_simple_irq);
+ set_irq_flags(irq, IRQF_VALID);
+ irq++;
+ }
+
+ ret = request_irq(INT_34XX_GPMC_IRQ,
+ gpmc_handle_irq, IRQF_SHARED, "gpmc", gpmc_base);
+ if (ret)
+ pr_err("gpmc: irq-%d could not claim: err %d\n",
+ INT_34XX_GPMC_IRQ, ret);
+ return ret;
+}
+postcore_initcall(gpmc_init);
+
+static irqreturn_t gpmc_handle_irq(int irq, void *dev)
+{
+ u8 cs;
+
+ if (irq != INT_34XX_GPMC_IRQ)
+ return IRQ_HANDLED;
+ /* check cs to invoke the irq */
+ cs = ((gpmc_read_reg(GPMC_PREFETCH_CONFIG1)) >> CS_NUM_SHIFT) & 0x7;
+ if (OMAP_GPMC_IRQ_BASE+cs <= OMAP_GPMC_IRQ_END)
+ generic_handle_irq(OMAP_GPMC_IRQ_BASE+cs);
+
+ return IRQ_HANDLED;
}
#ifdef CONFIG_ARCH_OMAP3
diff --git a/arch/arm/mach-omap2/io.c b/arch/arm/mach-omap2/io.c
index e66687b..b60287c 100644
--- a/arch/arm/mach-omap2/io.c
+++ b/arch/arm/mach-omap2/io.c
@@ -30,7 +30,6 @@
#include <plat/sram.h>
#include <plat/sdrc.h>
-#include <plat/gpmc.h>
#include <plat/serial.h>
#include "clock2xxx.h"
@@ -408,7 +407,6 @@ void __init omap2_init_common_devices(struct omap_sdrc_params *sdrc_cs0,
omap2_sdrc_init(sdrc_cs0, sdrc_cs1);
_omap2_init_reprogram_sdrc();
}
- gpmc_init();
omap_irq_base_init();
}
diff --git a/arch/arm/plat-omap/include/plat/gpmc.h b/arch/arm/plat-omap/include/plat/gpmc.h
index 85ded59..9c060da 100644
--- a/arch/arm/plat-omap/include/plat/gpmc.h
+++ b/arch/arm/plat-omap/include/plat/gpmc.h
@@ -41,6 +41,8 @@
#define GPMC_NAND_ADDRESS 0x0000000b
#define GPMC_NAND_DATA 0x0000000c
+#define GPMC_ENABLE_IRQ 0x0000000d
+
/* ECC commands */
#define GPMC_ECC_READ 0 /* Reset Hardware ECC for read */
#define GPMC_ECC_WRITE 1 /* Reset Hardware ECC for write */
@@ -78,6 +80,8 @@
#define WR_RD_PIN_MONITORING 0x00600000
#define GPMC_PREFETCH_STATUS_FIFO_CNT(val) ((val >> 24) & 0x7F)
#define GPMC_PREFETCH_STATUS_COUNT(val) (val & 0x00003fff)
+#define GPMC_IRQ_FIFOEVENTENABLE 0x01
+#define GPMC_IRQ_COUNT_EVENT 0x02
/*
* Note that all values in this struct are in nanoseconds except sync_clk
@@ -135,7 +139,6 @@ extern int gpmc_prefetch_enable(int cs, int dma_mode,
extern int gpmc_prefetch_reset(int cs);
extern void omap3_gpmc_save_context(void);
extern void omap3_gpmc_restore_context(void);
-extern void gpmc_init(void);
extern int gpmc_read_status(int cmd);
extern int gpmc_cs_configure(int cs, int cmd, int wval);
extern int gpmc_nand_read(int cs, int cmd);
diff --git a/arch/arm/plat-omap/include/plat/irqs.h b/arch/arm/plat-omap/include/plat/irqs.h
index 2910de9..1b91168 100644
--- a/arch/arm/plat-omap/include/plat/irqs.h
+++ b/arch/arm/plat-omap/include/plat/irqs.h
@@ -318,6 +318,7 @@
#define INT_34XX_PRCM_MPU_IRQ 11
#define INT_34XX_MCBSP1_IRQ 16
#define INT_34XX_MCBSP2_IRQ 17
+#define INT_34XX_GPMC_IRQ 20
#define INT_34XX_MCBSP3_IRQ 22
#define INT_34XX_MCBSP4_IRQ 23
#define INT_34XX_CAM_IRQ 24
@@ -411,7 +412,13 @@
#define TWL_IRQ_END TWL6030_IRQ_END
#endif
-#define NR_IRQS TWL_IRQ_END
+/* GPMC related */
+#define OMAP_GPMC_IRQ_BASE (TWL_IRQ_END)
+#define OMAP_GPMC_NR_IRQS 7
+#define OMAP_GPMC_IRQ_END (OMAP_GPMC_IRQ_BASE + OMAP_GPMC_NR_IRQS)
+
+
+#define NR_IRQS OMAP_GPMC_IRQ_END
#define OMAP_IRQ_BIT(irq) (1 << ((irq) % 32))
--
1.7.0.4
More information about the linux-mtd
mailing list