[PATCH] MTD/GPMI : select more modules for GPMI by default

[Huang Shijie]

于 2011年12月31日 15:01, Marek Vasut 写道:
>> 于 2011年12月31日 13:44, Shawn Guo 写道:
>>> On Fri, Dec 30, 2011 at 12:45:37PM +0800, Huang Shijie wrote:
>>>> The gpmi-nand driver needs the mxs-dma driver. So select the
>>>> MXS_DMA by default. So does the MTD_CHAR.
>>>>
>>>> Signed-off-by: Huang Shijie<b32955 at freescale.com>
>>>> ---
>>>>
>>>>    drivers/mtd/nand/Kconfig |    2 ++
>>>>    1 files changed, 2 insertions(+), 0 deletions(-)
>>>>
>>>> diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
>>>> index 07c4774..1b14a3a 100644
>>>> --- a/drivers/mtd/nand/Kconfig
>>>> +++ b/drivers/mtd/nand/Kconfig
>>>> @@ -420,6 +420,8 @@ config MTD_NAND_NANDSIM
>>>>
>>>>    config MTD_NAND_GPMI_NAND
>>>>
>>>>            bool "GPMI NAND Flash Controller driver"
>>>>            depends on MTD_NAND&&   (SOC_IMX23 || SOC_IMX28)
>>>>
>>>> +	select MXS_DMA
>>> We should probably have it depend on MXS_DMA rather than select it.
>> IMHO, I think `select` is better. :)
>> The MXS_DMA not only service for NAND, but SD card, etc.
>> In logic, the GPMI does not depends on MXS_DMA, the GPMI may use SDMA
>> too(just in logically).
> And does it use that ? Technically, it's still dependent on MXS_DMA, right ?
NO. Just assumption.

the GPMI driver will continue to depend on MXS_DMA in the following 
chips, such as MX6Q.


> Also, why select mtd_char, it's totally unrelated.
The GPMI works with UBIFS, the UBIFS is based on /dev/mtd0..,



Huang Shijie
> M
>>
>> Best Regards
>> Huang Shijie
>>
>>> Regards,
>>> Shawn
>>>
>>>> +	select MTD_CHAR
>>>>
>>>>    	select MTD_PARTITIONS
>>>>    	select MTD_CMDLINE_PARTS
>>>>    	
>>>>            help
>> _______________________________________________
>> linux-arm-kernel mailing list
>> linux-arm-kernel at lists.infradead.org
>> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel