[PATCH v9 1/3] MTD : add the common code for GPMI-NAND controller driver

[Huang Shijie]

Hi Artem:
> On Mon, 2011-08-22 at 12:34 +0800, Huang Shijie wrote:
>>>> +	pr_info("ECC Algorithm          : %s\n", geo->ecc_algorithm);
>>>> +	pr_info("ECC Strength           : %u\n", geo->ecc_strength);
>>>> +	pr_info("Page Size in Bytes     : %u\n", geo->page_size_in_bytes);
>>>> +	pr_info("Metadata Size in Bytes : %u\n", geo->metadata_size_in_bytes);
>>>> +	pr_info("ECC Chunk Size in Bytes: %u\n", geo->ecc_chunk_size_in_bytes);
>>>> +	pr_info("ECC Chunk Count        : %u\n", geo->ecc_chunk_count);
>>>> +	pr_info("Payload Size in Bytes  : %u\n", geo->payload_size_in_bytes);
>>>> +	pr_info("Auxiliary Size in Bytes: %u\n", geo->auxiliary_size_in_bytes);
>>>> +	pr_info("Auxiliary Status Offset: %u\n", geo->auxiliary_status_offset);
>>>> +	pr_info("Block Mark Byte Offset : %u\n", geo->block_mark_byte_offset);
>>>> +	pr_info("Block Mark Bit Offset  : %u\n", geo->block_mark_bit_offset);
>>>> +}
>>> Isn't it too much info for normal users? Should this be pr_debug()
>> the log is only printed out when the bug occurs.
>> so it's not for normal users.
>>> instead? There is another similar place in your code.
>>>
>> ok, I will change to pr_debug().
> I did not read the driver code carefully, so did not realize this is
> printed only in case of a bug - I thought this is printed on every boot
> up. For the bug case it may be OK to use pr_info as well, so I take back
> by comment about using pr_debug(), apologies.
>
thank you all the same :)

Huang Shijie