[PATCH] mtd-nand: davinci: correct 4-bit error correction

[Andrew Morton]

On Fri,  9 Jul 2010 10:59:49 +0530
Sudhakar Rajashekhara <sudhakar.raj at ti.com> wrote:

> +
> +	/*
> +	 * ECC_STATE field reads 0x3 (Error correction complete) immediately
> +	 * after setting the 4BITECC_ADD_CALC_START bit. So if you immediately
> +	 * begin trying to poll for the state, you may fall right out of your
> +	 * loop without any of the correction calculations having taken place.
> +	 * The recommendation from the hardware team is to wait till ECC_STATE
> +	 * reads less than 4, which means ECC HW has entered correction state.
> +	 */
> +	do {
> +		ecc_state = (davinci_nand_readl(info,
> +				NANDFSR_OFFSET) >> 8) & 0x0f;
> +		cpu_relax();
> +	} while ((ecc_state < 4) && time_before(jiffies, timeo));

An up-to-100-milliseond busy wait is pretty bad.  For how long do you
expect this to spin in practice?