ubi attach failure

[Artem Bityutskiy]

On Tue, 2010-01-05 at 18:16 -0500, twebb wrote:
> I get the error shown below when attempting to attach to an mtd device
> on a Marvell PXA-based platform.  The flash is MLC NAND from Samsung
> K9LBG08U0D (4G x 8-bit).
> 
> I don't know if it's related, but one thing that stands out is that I
> only see the error on two platforms whose bad block table has >28
> entries (other tested boards have approx. 2-8 bad blocks).
> 
> Any suggestion as to what would cause error and whether it may be
> related to the high number of bad blocks?

What did you use to flash your image? It looks like it was not flashed
properly.

-- 
Best Regards,
Artem Bityutskiy (Артём Битюцкий)