RFC: [PATCH V2 0/9 Integration of SmartMedia/xD into mtd subsystem

[Maxim Levitsky]

On Fri, 2010-01-08 at 17:04 +0100, Jörn Engel wrote: 
> On Fri, 8 January 2010 17:04:52 +0200, Maxim Levitsky wrote:
> > 
> > * Write speed is of course still very low, but like I said, it might be
> > hardware problem.
> 
> Iirc the alauda could do about 400kB/s.  Speed didn't change noticeably
> between 16M and 256M cards.  My conclusion back then was to blame the
> alauda chip.  If you get even less, the problem likely isn't in the
> cards but in the reader and/or your driver.
Who knows...
Like I said, I get around 330 Kbytes/s in card reader integrated in
printer. It is still much higher that what I get with this driver....

I will figure that out sooner or later.

Btw, your cards aren't Type M, right?
However I use here a Type M card, and its likely to include an FTL
inside, thus, it might explain the low speeds I get there partially...

Best regards,
Maxim Levitsky