[PATCH] NAND: add support for reading ONFI parameters from NAND device

Maxime Bizon mbizon at freebox.fr
Thu Aug 5 08:56:13 EDT 2010

On Thu, 2010-08-05 at 07:54 +0300, Artem Bityutskiy wrote:
> On Thu, 2010-07-29 at 00:47 +0200, Florian Fainelli wrote:
> > A nand_chip which has valid ONFI parameters gets its options field updated
> > with the NAND_ONFI flag. In that case both the ONFI version (in BCD format)
> > as well as the complete page parameters is available in the struct nand_chip.
> > This allows for better detection of some new devices, as well as fine tuning of
> > NAND driver timings. This patch only adds support for ONFI 1.0 parameters.
> > 
> > Signed-off-by: Maxime Bizon <mbizon at freebox.fr>
> > Signed-off-by: Florian Fainelli <ffainelli at freebox.fr>
> I assume you will send v2 of this patch, so not taking this one.

Please don't

We still need to address all remarks Matthieu did, and of course gives
this more testing (this was more an "RFC" than a "PATCH", sorry)


More information about the linux-mtd mailing list