NAND: Add flags to the probe calls to control scan behaviour

[Artem Bityutskiy]

On Mon, 2009-10-19 at 11:36 +0100, Ben Dooks wrote:
> I'd rather it be silent if it cannot find a device, as a number of our boards
> have slots where NAND devices may be fitted by the customer and as such all
> possibilities are registered with the NAND driver.
> 
> > Could you please elaborate why more why is this needed a bit more? What
> > is the driver?
> 
> Because customers get scared when errors with '!!!' turn up.

> > Why not to just remove that print at all?
> 
> Possible, but what about the case where there is a legitimate problem with
> the device that is supposed to be there.

I would go for this instead. I think the drivers can print an error
message themselves.

Or can this be done using the chip->options ?
-- 
Best Regards,
Artem Bityutskiy (Артём Битюцкий)