[PATCH 2/2] NAND on DM355: Add 4-bit ECC support for large page NAND chips

[vimal singh]

On Thu, May 7, 2009 at 12:46 PM, David Brownell <david-b at pacbell.net> wrote:
> I'm glad to see this patch is so small ... basically, just
> adding a special case for 2K pages, and keeping the core of
> this NAND driver the same.  Not needing to change the 4-bit
> ECC support from the patch I sent earlier seems a good sign.
>
> Two comments though:  (a) the board-dm355-evm.c file isn't
> yet in mainline, so the MTD folk can't take this patch as-is;
> (b) as noted elsewhere, there are still issues with 4K pages
> and the NAND core infrastructure.
>
> This patch is sufficient to support development boards for
> the dm355, dm357, and dm365 ... right?  They all have 2 GByte
> NAND chips, ISTR with 2K pages, and haven't yet had to switch
> to more current parts with 4K pages.
>
>
> On Wednesday 06 May 2009, nsnehaprabha at ti.com wrote:
>> --- a/drivers/mtd/nand/davinci_nand.c
>> +++ b/drivers/mtd/nand/davinci_nand.c
>> @@ -500,6 +500,21 @@ static struct nand_ecclayout hwecc4_small __initconst
>> = { },
>>  };
>>
>> +/* An ECC layout for using 4-bit ECC with large-page (2048bytes) flash,
>> + * storing ten ECC bytes plus the manufacturer's bad block marker byte,
>> + * and not overlapping the default BBT markers.
>> + */
>> +static struct nand_ecclayout hwecc4_2048 __initconst = {
>> +       .eccbytes = 10,
>
> Not ".eccbytes = 40"?  This is 4 chunks, 10 ecc bytes each...
>
>
>> +       .eccpos = { 0, 1, 2, 3, 4, 6, 7, 8, 9, 10,
>> +               11, 12, 13, 14, 15, 24, 25, 26, 27, 28,
>> +               29, 30, 31, 32, 33, 34, 35, 36, 37, 38,
>> +               39, 40, 41, 42, 43, 44, 45, 46, 47, 48, },
>> +       .oobfree = {
>> +               {.offset = 16, .length = 8, },
>> +               {.offset = 49, },
>
> Comments would be good, highlighting (a) byte 5 is reserved,
> it's the manufacturer bad block marker, (b) 8 bytes @16 are
> expected by JFFS2.  Not everyone will "just know" those.
How about leaving bytes '4' and '5' for bad block marker, to support 16-bit
NAND parts too.

---
Regards,
\/ | |\/| /-\ |_