Bad Block Table support when using UBI

Torsten Fleischer torsten.fleischer at kathrein.de
Thu Feb 19 01:07:53 EST 2009


Hi all,

I've tested UBI and UBIFS on the eval board MPC8313ERDB. This board 
contains a 32 MiB NAND Flash (SLC small block).
The fsl_elbc_nand driver that is used for the MPC8313's NAND flash 
interface reserves 4 erase blocks at the end of the device
for the bad block table.

Do I need the bad block table support when using UBI?

Best regards
Torsten Fleischer



-- 
Registergericht / Register court: Amtsgericht Traunstein, HRA 460 / local court Traunstein, certificate of registration no. 460 
Geschäftsführender persönlich haftender Gesellschafter / Personally liable managing partner: Prof. Dr. Dr. h.c. Anton Kathrein, Dipl.-Betriebswirt (MBA-equivalent) 
Erfüllungsort und Gerichtsstand / Place of performance and place of jurisdiction: Rosenheim 

This e-mail is confidential and may contain privileged information. If you have received this communication in error, please notify us immediately by responding to this email and then delete it from your system. The sender therefore does not accept liability for any errors or omissions in the contents of this message which arise as a result of e-mail transmission. We believe but do not warrant that this e-mail and any attachments are virus free. You must therefore take full responsibility for virus checking. 



More information about the linux-mtd mailing list