[PATCH] Bug on atmel_nand HW ECC : OOB info not correctly written

[Haavard Skinnemoen]

Richard Genoud wrote:
> Have you some feed-back on this patch ?
> Justin tested it successfully with a Samsung K9F2G08U0M-PCB0 256 MiB
> with 2048 Byte page size
> and 128 KiB Erase Block size on an at91sam9260-ek.

Sorry about not responding earlier, but FWIW, I have successfully
booted a avr32 board after this patch was merged, and I can't see any
obvious problems. So I think it works fine.

The NAND chip I have is also a Samsung one:

NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung NAND 256MiB 3,3V 8-bit)

with 2K page size.

Haavard