[PATCH] Blackfin BF54x NAND Flash Controller driver

[Bryan Wu]

On Mon, 2007-09-03 at 13:57 -0400, Mike Frysinger wrote:
> On 9/3/07, Bryan Wu <bryan.wu at analog.com> wrote:
> > --- a/drivers/mtd/nand/Kconfig
> > +++ b/drivers/mtd/nand/Kconfig
> > @@ -131,6 +131,24 @@ config MTD_NAND_AU1550
> > +config MTD_NAND_BF54X
> > +       tristate "NAND Flash support for Blackfin BF54X SoC DSP"
> 
> i'd just describe it as "Blackfin on-chip NAND" rather than sticking
> in exact part numbers as i imagine we can extend it down the line
> 
> > +         This enables the NAND flash controller on the BF54X SoC DPSs
> 
> "BF54X SoC DPSs" -> "BF54x SoC DSPs"
> 
> > +         No board specific support is done by this driver, each board
> > +         must advertise a platform_device for the driver to attach.
> 
> should mention the module name when built as a module
> 

I will get rid of this BF54X and use BF5XX for (BF54x and BF52x and
future processor)

> > +config MTD_NAND_BF54X_HWECC
> > +       bool "BF54X NAND Hardware ECC"
> > +       depends on MTD_NAND_BF54X
> > +       help
> > +         Enable the use of the BF54X's internal ECC generator when
> > +         using NAND. Early versions of the chip have had problems with
> > +         incorrect ECC generation, and if using these, the default of
> > +         software ECC is preferable.
> 
> rather than advertising this, i'd just keep it in the driver ...
> presumably there are anomaly #'s for when the ECC is wrong, so we can
> make the code depend on those
> -mike

This option is quite common in the NAND driver. If there are anomaly
#'s, code can still depend on those by using hardware_ecc varible. This
option is very useful when someone need software_ecc.

Thanks
- Bryan Wu