Problem with developing Samsung K9F1G08U0A MTD driver

[z l]

> might help, on the R1 device is 128M, the U device
is 256M(so am not too
> sure abt ur mtd.size param), on this device,
page1,page2 offset 0 had
> badblock info, so am not sure if mtd is putting ecc
over there..
I doubled checked the datasheet, R is 1.8v device, U
is 3.3v.

> mebbe u can try this: (dunno if it works):
flash_eraseall mtd and mount
> and umount the same, let jffs2 maintain the bad
blocks - remount should
> not show any jffs2 errors.
Is it possible to mount a bare MTD device?

> Just my guesses.. but then.. I can be completely
wrong...
Thanks for the help.