[PATCH] PHYSMAP depens on CFI or JEDECPROBE or ROM

[takasi-y at ops.dti.ne.jp]

# posting it agein.
map/physmap.c tries to probe "cfi_probe", "jedec_probe" and "map_rom", but
map/Kconfig says it depends on MTD_CFI only.
This patch adds  MTD_JEDECPROBE and MTD_ROM to the dependency condition.

Signed-off-by: Takashi YOSHII <takasi-y at ops.dti.ne.jp>
---
Index: drivers/mtd/maps/Kconfig
===================================================================
RCS file: /home/cvs/mtd/drivers/mtd/maps/Kconfig,v
retrieving revision 1.69
diff -u -p -r1.69 Kconfig
--- drivers/mtd/maps/Kconfig	28 Mar 2006 16:15:53 -0000	1.69
+++ drivers/mtd/maps/Kconfig	4 Aug 2006 14:00:58 -0000
@@ -13,13 +13,13 @@ config MTD_COMPLEX_MAPPINGS
 
 config MTD_PHYSMAP
 	tristate "CFI Flash device in physical memory map"
-	depends on MTD_CFI
+	depends on MTD_CFI || MTD_JEDECPROBE || MTD_ROM
 	help
-	  This provides a 'mapping' driver which allows the CFI probe and
-	  command set driver code to communicate with flash chips which
-	  are mapped physically into the CPU's memory. You will need to
-	  configure the physical address and size of the flash chips on
-	  your particular board as well as the bus width, either statically
+	  This provides a 'mapping' driver which allows the NOR Flash and
+	  ROM driver code to communicate with chips which are mapped
+	  physically into the CPU's memory. You will need to configure
+	  the physical address and size of the flash chips on your
+	  particular board as well as the bus width, either statically
 	  with config options or at run-time.
 
 config MTD_PHYSMAP_START