mtdpart.c

[Bjorn Wesen]

On Fri, 12 Jan 2001, David Woodhouse wrote:
> > in mtdpart.c which is not in the Makefile.. is it safe to use this or
> > should I conjure up partition code myself in my mapping ? 
> 
> Use mtdpart.c

Ok great!

Axis flash mapping: 200000 at e0000000
Axis flash-image: Found a CFI device at 0x0 in 16 bit mode
Primary Vendor Command Set: 0002 (AMD/Fujitsu Standard)
Primary Algorithm Table at 0040
Alternative Vendor Command Set: 0000 (None)
No Alternate Algorithm Table
Vcc Minimum: 2.7 V
Vcc Maximum: 3.6 V
No Vpp line
Typical byte/word write timeout: 16 µs
Maximum byte/word write timeout: 512 µs
Full buffer write not supported
Typical block erase timeout: 1024 µs
Maximum block erase timeout: 16384 µs
Chip erase not supported
Device size: 0x200000 bytes (2 Mb)
Flash Device Interface description: 0x0002
  - supports x8 and x16 via BYTE# with asynchronous interface
Max. bytes in buffer write: 0x1
Number of Erase Block Regions: 4
  Erase Region #0: BlockSize 0x4000 bytes, 1 blocks
  Erase Region #1: BlockSize 0x2000 bytes, 2 blocks
  Erase Region #2: BlockSize 0x8000 bytes, 1 blocks
  Erase Region #3: BlockSize 0x10000 bytes, 31 blocks

Invalid Extended Query Table at 0040: 02 00 F2
No supported Vendor Command Set found
cfi_probe erred 0


:(

Wonder where it blew up - maybe I should dump the latest mtd cvs (using
2.4.0 release now)

/BW




To unsubscribe, send "unsubscribe mtd" to majordomo at infradead.org