Question about cfi_cmdset_0001.c

Stefan Thomasson st at
Thu Aug 23 12:47:30 EDT 2001


I have discovered some problems with the strataflash memory and resets 
on our board (strongarm assabet clone), 
and after looking in this file I discovered that after erasing and
writing, the
state of the chips are left in FL_STATUS. 

Which in our case results in the status is output after reset if it
happens before any reads from flash.

Is there a reason not to enter read array mode / FL_READY.

Best regards

Stefan Thomasson

More information about the linux-mtd mailing list