[PATCH v2 11/21] arm64: dts: apple: t8103-j313: Add speaker/headset jack nodes

[Ajay Kumar Nandam]

On 10/8/2026 2:16 PM, James Calligeros wrote:
> On Thu, Oct 8, 2026 at 4:33 AM Ajay Kumar Nandam
> <ajay.nandam at oss.qualcomm.com> wrote:
>>
>>
>>
>> On 10/4/2026 11:33 AM, James Calligeros wrote:
>>> +&i2c3 {
>>> +     status = "okay";
>>> +
>>> +     speaker_right: codec at 34 {
>>> +             compatible = "ti,tas5770l";
>>> +             reg = <0x34>;
>>> +             interrupts-extended = <&pinctrl_ap 182 IRQ_TYPE_LEVEL_LOW>;
>>> +             shutdown-gpios = <&pinctrl_ap 181 GPIO_ACTIVE_HIGH>;
>>> +             #sound-dai-cells = <0>;
>>
>> Both speaker codec nodes reference the same shutdown GPIO. Is that
>> intentional for this board?
>>
>> The TAS2770 driver requests 'shutdown-gpios' per codec instance, and
>> GPIO requests are exclusive by default. So I would expect only one codec
>> instance to own this line, while the other appears to fall back to the
>> register-only path after the GPIO request fails.
>>
>> If GPIO181 is a shared physical shutdown line for both amps, how is the
>> power/reset ordering expected to work across probe, suspend, and resume
>> when only one of the two codec driver instances controls that line?
> 
> We use the new(ish) shared GPIO proxy stuff[1] and it all Just Works.
> 
> [1] https://lore.kernel.org/asahi/20260831-apple-shared-gpio-v1-0-e855b12e18ce@gmail.com/

Thanks for pointing that out. I missed the shared GPIO proxy dependency
when looking at the DTS nodes.

That addresses my concern about the shared shutdown line.

Thanks
Ajay Kumar Nandam