[PATCH v2 10/21] arm64: dts: apple: t8103-j274: Add speaker/headset jack nodes

[Ajay Kumar Nandam]

On 10/4/2026 11:33 AM, James Calligeros wrote:
> The M1 Mac mini integrates Apple-specific variants of the TI TAS2770
> and Cirrus CS42L42. Add these nodes and advertise them to the machine
> driver via the sound node.
> 
> Signed-off-by: James Calligeros <jcalligeros99 at gmail.com>
> ---
>   arch/arm64/boot/dts/apple/t8103-j274.dts | 67 +++++++++++++++++++++++++
>   1 file changed, 67 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/apple/t8103-j274.dts b/arch/arm64/boot/dts/apple/t8103-j274.dts
> index 1212852251e0..6121e3a89a0f 100644
> --- a/arch/arm64/boot/dts/apple/t8103-j274.dts
> +++ b/arch/arm64/boot/dts/apple/t8103-j274.dts
> @@ -75,4 +75,71 @@ &i2c2 {
>   	status = "okay";
>   };
>   
> +/* Audio codecs */
> +&i2c1 {
> +	status = "okay";
> +
> +	speaker: codec at 31 {
> +		compatible = "ti,tas5770l";
> +		reg = <0x31>;

The binding documents "ti,tas5770l" in 
'Documentation/devicetree/bindings/sound/ti,tas2770.yaml', but I only 
see 'ti,tas2770' in the OF match table in 'sound/soc/codecs/tas2770.c'.

Is the expectation that this node should bind through the TAS2770 
driver? If so, should this either use a generic fallback compatible, for 
example:

compatible = "ti,tas5770l", "ti,tas2770";

or add `ti,tas5770l` to the driver's OF match table?


> +		interrupts-extended = <&pinctrl_ap 182 IRQ_TYPE_LEVEL_LOW>;
> +		shutdown-gpios = <&pinctrl_ap 181 GPIO_ACTIVE_HIGH>;
> +		#sound-dai-cells = <0>;
> +		ti,imon-slot-no = <0>;