[PATCH mt76] wifi: mt76: mt7915: configure noise floor reporting on reset

[David Bauer]

When performing a full system recovery of the MCU on a dual-phy
platform, band 0 (usually 2.4GHz) stops reading correct noise floor
data.

This is due to noise floor reporting only being configured correctly
for the second device PHY.

Configure the respective registers correctly after restarting the MCU
firmware to fix reported noise-floor values.

Signed-off-by: David Bauer <mail at david-bauer.net>
---
 drivers/net/wireless/mediatek/mt76/mt7915/main.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/net/wireless/mediatek/mt76/mt7915/main.c b/drivers/net/wireless/mediatek/mt76/mt7915/main.c
index e1d83052aa6dd..b42c26d0d09a4 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7915/main.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7915/main.c
@@ -25,11 +25,13 @@ int mt7915_run(struct ieee80211_hw *hw)
 	struct mt7915_dev *dev = mt7915_hw_dev(hw);
 	struct mt7915_phy *phy = mt7915_hw_phy(hw);
 	bool running;
+	bool reset;
 	int ret;
 
 	running = mt7915_dev_running(dev);
+	reset = test_bit(MT76_RESET, &phy->mt76->state);
 
-	if (!running) {
+	if (!running || (reset && phy == &dev->phy)) {
 		ret = mt76_connac_mcu_set_pm(&dev->mt76,
 					     dev->phy.mt76->band_idx, 0);
 		if (ret)
-- 
2.53.0