[PATCH v10 03/26] dt-bindings: ufs: mediatek,ufs: Add mt8196 variant

Louis-Alexis Eyraud louisalexis.eyraud at collabora.com
Thu Jul 30 02:48:59 PDT 2026


From: Nicolas Frattaroli <nicolas.frattaroli at collabora.com>

The MediaTek MT8196 SoC's UFS controller uses a different set of supplies.
It is therefore not compatible with the MT8195.

While it does have a AVDD09_UFS_1 pin in addition to the AVDD09_UFS pin,
it appears that these two pins are commoned together, as the board
schematic I have access to uses the same supply for both, and the
downstream driver does not distinguish between the two supplies either.

Add a compatible for it, and modify the binding correspondingly.

Signed-off-by: Nicolas Frattaroli <nicolas.frattaroli at collabora.com>
Signed-off-by: Louis-Alexis Eyraud <louisalexis.eyraud at collabora.com>
---
 .../devicetree/bindings/ufs/mediatek,ufs.yaml      | 45 ++++++++++++++++++++++
 1 file changed, 45 insertions(+)

diff --git a/Documentation/devicetree/bindings/ufs/mediatek,ufs.yaml b/Documentation/devicetree/bindings/ufs/mediatek,ufs.yaml
index e7e360c59ba5..70164e4e54c5 100644
--- a/Documentation/devicetree/bindings/ufs/mediatek,ufs.yaml
+++ b/Documentation/devicetree/bindings/ufs/mediatek,ufs.yaml
@@ -16,6 +16,7 @@ properties:
       - mediatek,mt8183-ufshci
       - mediatek,mt8192-ufshci
       - mediatek,mt8195-ufshci
+      - mediatek,mt8196-ufshci
 
   clocks:
     minItems: 1
@@ -131,6 +132,20 @@ allOf:
         clock-names:
           minItems: 10
         avdd09-supply: false
+  - if:
+      properties:
+        compatible:
+          contains:
+            const: mediatek,mt8196-ufshci
+    then:
+      properties:
+        clocks:
+          minItems: 10
+        clock-names:
+          minItems: 10
+        avdd18-supply: false
+      required:
+        - operating-points-v2
 
 examples:
   - |
@@ -177,3 +192,33 @@ examples:
 
         mediatek,ufs-disable-mcq;
     };
+  - |
+    #include <dt-bindings/reset/mediatek,mt8196-resets.h>
+    #include <dt-bindings/interrupt-controller/arm-gic.h>
+
+    ufshci at 16810000 {
+        compatible = "mediatek,mt8196-ufshci";
+        reg = <0x16810000 0x2a00>;
+        interrupts = <GIC_SPI 320 IRQ_TYPE_LEVEL_HIGH>;
+
+        clocks = <&ufs_ao_clk 6>, <&ufs_ao_clk 7>, <&clk26m>, <&ufs_ao_clk 3>,
+                 <&clk26m>, <&ufs_ao_clk 4>, <&ufs_ao_clk 0>,
+                 <&topckgen 7>, <&ufs_ao_clk 1>, <&ufs_ao_clk 2>;
+        clock-names = "main", "aes", "tick", "unipro_sysclk",
+                      "unipro_tick", "unipro_mp_bclk", "tx_symbol",
+                      "mem_sub", "rx_symbol0", "rx_symbol1";
+
+        operating-points-v2 = <&ufs_opp_table>;
+
+        phys = <&ufsphy>;
+
+        avdd09-supply = <&mt6363_vsram_modem>;
+        vcc-supply = <&mt6363_vemc>;
+        vccq-supply = <&mt6363_vufs12>;
+
+        resets = <&ufs_ao_clk MT8196_UFSAO_RST1_UFS_UNIPRO>,
+                 <&ufs_ao_clk MT8196_UFSAO_RST1_UFS_CRYPTO>,
+                 <&ufs_ao_clk MT8196_UFSAO_RST1_UFSHCI>;
+        reset-names = "unipro", "crypto", "hci";
+        mediatek,ufs-disable-mcq;
+    };

-- 
2.55.0




More information about the Linux-mediatek mailing list