[PATCH 5/5] wifi: mt76: mt7996: fix queue pause after scan due to wrong channel switch reason

[Felix Fietkau]

On 02.02.26 08:53, Shayne Chen wrote:
> From: StanleyYP Wang <StanleyYP.Wang at mediatek.com>
> 
> Previously, we use the IEEE80211_CONF_IDLE flag to avoid setting the
> parking channel with the CH_SWITCH_NORMAL reason, which could trigger TX
> emission before bootup CAC.
> 
> However, we found that this flag can be set after triggering scanning on a
> connected station interface, and the reason CH_SWITCH_SCAN_BYPASS_DPD will
> be used when switching back to the operating channel, which makes the
> firmware failed to resume paused AC queues.
> 
> Seems that we should avoid relying on this flag after switching to single
> multi-radio architecture. Instead, replace it with MT76_STATE_RUNNING.

I don't see how the conditions are comparable at all. I also don't see 
how this function can be called with MT76_STATE_RUNNING unset.

Maybe a better replacement would be to check for a chanctx on the phy?

- Felix