[PATCH AUTOSEL 6.12 061/486] wifi: mt76: mt7996: fix SER reset trigger on WED reset

[Sasha Levin]

From: Rex Lu <rex.lu at mediatek.com>

[ Upstream commit 8d38abdf6c182225c5c0a81451fa51b7b36a635d ]

The firmware needs a specific trigger when WED is being reset due to an
ethernet reset condition. This helps prevent further L1 SER failure.

Signed-off-by: Rex Lu <rex.lu at mediatek.com>
Link: https://patch.msgid.link/20250311103646.43346-2-nbd@nbd.name
Signed-off-by: Felix Fietkau <nbd at nbd.name>
Signed-off-by: Sasha Levin <sashal at kernel.org>
---
 drivers/net/wireless/mediatek/mt76/mt7996/mcu.h  | 3 ++-
 drivers/net/wireless/mediatek/mt76/mt7996/mmio.c | 2 +-
 2 files changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/net/wireless/mediatek/mt76/mt7996/mcu.h b/drivers/net/wireless/mediatek/mt76/mt7996/mcu.h
index 43468bcaffc6d..a75e1c9435bb0 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7996/mcu.h
+++ b/drivers/net/wireless/mediatek/mt76/mt7996/mcu.h
@@ -908,7 +908,8 @@ enum {
 	UNI_CMD_SER_SET_RECOVER_L3_TX_DISABLE,
 	UNI_CMD_SER_SET_RECOVER_L3_BF,
 	UNI_CMD_SER_SET_RECOVER_L4_MDP,
-	UNI_CMD_SER_SET_RECOVER_FULL,
+	UNI_CMD_SER_SET_RECOVER_FROM_ETH,
+	UNI_CMD_SER_SET_RECOVER_FULL = 8,
 	UNI_CMD_SER_SET_SYSTEM_ASSERT,
 	/* action */
 	UNI_CMD_SER_ENABLE = 1,
diff --git a/drivers/net/wireless/mediatek/mt76/mt7996/mmio.c b/drivers/net/wireless/mediatek/mt76/mt7996/mmio.c
index 442f72450352b..b6209ed1cfe01 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7996/mmio.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7996/mmio.c
@@ -281,7 +281,7 @@ static int mt7996_mmio_wed_reset(struct mtk_wed_device *wed)
 	if (test_and_set_bit(MT76_STATE_WED_RESET, &mphy->state))
 		return -EBUSY;
 
-	ret = mt7996_mcu_set_ser(dev, UNI_CMD_SER_TRIGGER, UNI_CMD_SER_SET_RECOVER_L1,
+	ret = mt7996_mcu_set_ser(dev, UNI_CMD_SER_TRIGGER, UNI_CMD_SER_SET_RECOVER_FROM_ETH,
 				 mphy->band_idx);
 	if (ret)
 		goto out;
-- 
2.39.5