[PATCH net-next v2 5/5] net: phylink: provide fixed state for 1000base-X and 2500base-X
Vladimir Oltean
olteanv at gmail.com
Tue Jan 14 04:57:39 PST 2025
On Mon, Jan 13, 2025 at 09:22:44AM +0000, Russell King (Oracle) wrote:
> When decoding clause 22 state, if in-band is disabled and using either
> 1000base-X or 2500base-X, rather than reporting link-down, we know the
> speed, and we only support full duplex. Pause modes taken from XPCS.
>
> This fixes a problem reported by Eric Woudstra.
>
> Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
> ---
> drivers/net/phy/phylink.c | 29 +++++++++++++++++++----------
> 1 file changed, 19 insertions(+), 10 deletions(-)
>
> diff --git a/drivers/net/phy/phylink.c b/drivers/net/phy/phylink.c
> index b79f975bc164..ff0efb52189f 100644
> --- a/drivers/net/phy/phylink.c
> +++ b/drivers/net/phy/phylink.c
> @@ -3882,27 +3882,36 @@ void phylink_mii_c22_pcs_decode_state(struct phylink_link_state *state,
> if (!state->link)
> return;
>
> - /* If in-band is disabled, then the advertisement data is not
> - * meaningful.
> - */
> - if (neg_mode != PHYLINK_PCS_NEG_INBAND_ENABLED)
> - return;
> -
> switch (state->interface) {
> case PHY_INTERFACE_MODE_1000BASEX:
> - phylink_decode_c37_word(state, lpa, SPEED_1000);
> + if (neg_mode == PHYLINK_PCS_NEG_INBAND_ENABLED) {
> + phylink_decode_c37_word(state, lpa, SPEED_1000);
> + } else {
> + state->speed = SPEED_1000;
> + state->duplex = DUPLEX_FULL;
> + state->pause |= MLO_PAUSE_TX | MLO_PAUSE_RX;
> + }
> break;
>
> case PHY_INTERFACE_MODE_2500BASEX:
> - phylink_decode_c37_word(state, lpa, SPEED_2500);
> + if (neg_mode == PHYLINK_PCS_NEG_INBAND_ENABLED) {
> + phylink_decode_c37_word(state, lpa, SPEED_2500);
> + } else {
> + state->speed = SPEED_2500;
> + state->duplex = DUPLEX_FULL;
> + state->pause |= MLO_PAUSE_TX | MLO_PAUSE_RX;
> + }
> break;
Are the "else" branches necessary, given the "else" branch from
phylink_mac_pcs_get_state?
static void phylink_mac_pcs_get_state(struct phylink *pl,
struct phylink_link_state *state)
{
struct phylink_pcs *pcs;
bool autoneg;
linkmode_copy(state->advertising, pl->link_config.advertising);
linkmode_zero(state->lp_advertising);
state->interface = pl->link_config.interface;
state->rate_matching = pl->link_config.rate_matching;
state->an_complete = 0;
state->link = 1;
pcs = pl->pcs;
if (!pcs || pcs->neg_mode)
autoneg = pl->pcs_neg_mode == PHYLINK_PCS_NEG_INBAND_ENABLED;
else
autoneg = linkmode_test_bit(ETHTOOL_LINK_MODE_Autoneg_BIT,
state->advertising);
if (autoneg) {
state->speed = SPEED_UNKNOWN;
state->duplex = DUPLEX_UNKNOWN;
state->pause = MLO_PAUSE_NONE;
} else { |
state->speed = pl->link_config.speed; |
state->duplex = pl->link_config.duplex; | this
state->pause = pl->link_config.pause; |
} |
if (pcs)
pcs->ops->pcs_get_state(pcs, pl->pcs_neg_mode, state);
else
state->link = 0;
}
More information about the Linux-mediatek
mailing list