[PATCH 8/9] arm64: dts: mediatek: mt8183-kukui: Fix pull-down/up-adv values

[AngeloGioacchino Del Regno]

Il 01/08/25 13:18, Julien Massot ha scritto:
> The properties `mediatek,pull-up-adv` and `mediatek,pull-down-adv`
> were using incorrect values like `<10>` and `<01>`. These values
> are parsed as decimal (10 and 1 respectively), not binary.
> 
> However, the driver interprets these as bitfields:
>    - BIT(0): R0
>    - BIT(1): R1
> 
> So valid values are:
>    - 0 => no pull
>    - 1 => enable R0
>    - 2 => enable R1
>    - 3 => enable R0 + R1
> 
> Using `<10>` is invalid as it exceeds the accepted range.
> It was likely intended as binary `0b10` (i.e., `2`),
> to enable R1 only.
> 
> This patch replaces incorrect values with the correct ones
> and removes the leading zero from `<01>` to avoid confusion
> with bitfield notation.
> 
> Signed-off-by: Julien Massot <julien.massot at collabora.com>


Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno at collabora.com>