[net-next PATCH v2 2/2] net: phy: mediatek: add Airoha PHY ID to SoC driver

[Christian Marangi]

On Thu, Apr 10, 2025 at 08:07:33PM +0100, Simon Horman wrote:
> On Thu, Apr 10, 2025 at 12:04:04PM +0200, Christian Marangi wrote:
> > Airoha AN7581 SoC ship with a Switch based on the MT753x Switch embedded
> > in other SoC like the MT7581 and the MT7988. Similar to these they
> > require configuring some pin to enable LED PHYs.
> > 
> > Add support for the PHY ID for the Airoha embedded Switch and define a
> > simple probe function to toggle these pins. Also fill the LED functions
> > and add dedicated function to define LED polarity.
> > 
> > Reviewed-by: Andrew Lunn <andrew at lunn.ch>
> > Signed-off-by: Christian Marangi <ansuelsmth at gmail.com>
> 
> ...
> 
> > diff --git a/drivers/net/phy/mediatek/mtk-ge-soc.c b/drivers/net/phy/mediatek/mtk-ge-soc.c
> 
> ...
> 
> > +static int an7581_phy_led_polarity_set(struct phy_device *phydev, int index,
> > +				       unsigned long modes)
> > +{
> > +	u32 mode;
> > +	u16 val;
> > +
> > +	if (index >= MTK_PHY_MAX_LEDS)
> > +		return -EINVAL;
> > +
> > +	for_each_set_bit(mode, &modes, __PHY_LED_MODES_NUM) {
> > +		switch (mode) {
> > +		case PHY_LED_ACTIVE_LOW:
> > +			val = MTK_PHY_LED_ON_POLARITY;
> > +			break;
> > +		case PHY_LED_ACTIVE_HIGH:
> > +			val = 0;
> > +			break;
> > +		default:
> > +			return -EINVAL;
> > +		}
> > +	}
> > +
> > +	return phy_modify_mmd(phydev, MDIO_MMD_VEND2, index ?
> > +			      MTK_PHY_LED1_ON_CTRL : MTK_PHY_LED0_ON_CTRL,
> > +			      MTK_PHY_LED_ON_POLARITY, val);
> 
> Hi Christian,
> 
> Perhaps this cannot occur in practice, but if the for_each_set_bit
> loop iterates zero times then val will be used uninitialised here.
> 
> Flagged by Smatch.
> 
> > +}
> 
> ...

Almost impossible but yes I will post a follow-up patch fixing this!

-- 
	Ansuel