[PATCH RESEND,v6 2/8] dt-bindings: mailbox: Add property for CMDQ secure driver

[Rob Herring (Arm)]

On Sun, 26 May 2024 22:44:37 +0800, Jason-JH.Lin wrote:
> 1. Add mboxes property to define a GCE loopping thread as a secure IRQ
> handler.
> The CMDQ secure driver requests a mbox channel and sends a looping
> command to the GCE thread. The looping command will wait for a secure
> packet done event signal from secure world and then jump back to the
> first instuction. Each time it waits for an event, it notifies the
> CMDQ driver to perform the same action as the IRQ handler.
> 
> 2. Add gce-events property from gce-props.yaml to define a
> secure packet done signal in secure world.
> There are 1024 events IDs for GCE to use to execute instructions in
> the specific event happened. These events could be signaled by HW or SW
> and their value would be different in different SoC because of HW event
> IDs distribution range from 0 to 1023.
> If we set a static event ID: 855 for mt8188, it might be conflict the
> event ID original set in mt8195.
> So we define an event ID that will be set when GCE runs to the end of
> secure cmdq packet in the secure world.
> 
> This can reduce the latency of software communication between normal
> world and secure world. In addition, we can also remove the complex
> logic after the secure packet done in the secure world.
> 
> Signed-off-by: Jason-JH.Lin <jason-jh.lin at mediatek.com>
> Signed-off-by: Hsiao Chien Sung <shawn.sung at mediatek.com>
> ---
>  .../devicetree/bindings/mailbox/mediatek,gce-mailbox.yaml | 8 +++++++-
>  1 file changed, 7 insertions(+), 1 deletion(-)
> 

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/mailbox/mediatek,gce-mailbox.example.dtb: mailbox at 10212000: False schema does not allow {'compatible': ['mediatek,mt8173-gce'], 'reg': [[0, 270606336, 0, 4096]], 'interrupts': [[0, 135, 8]], '#mbox-cells': [[2]], 'clocks': [[4294967295, 4]], 'clock-names': ['gce'], '$nodename': ['mailbox at 10212000']}
	from schema $id: http://devicetree.org/schemas/mailbox/mediatek,gce-mailbox.yaml#

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20240526144443.14345-3-jason-jh.lin@mediatek.com

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.