[PATCH v4 15/15] arm64: dts: mediatek: add display support for mt8365-evk

Alexandre Mergnat amergnat at baylibre.com
Thu May 23 05:49:28 PDT 2024


MIPI DSI:
- Add "vsys_lcm_reg" regulator support and setup the "mt6357_vsim1_reg",
to power the pannel plugged to the DSI connector.
- Setup the Display Parallel Interface.
  - Add the startek kd070fhfid015 pannel support.

HDMI:
- Add HDMI connector support.
- Add the "ite,it66121" HDMI bridge support, driven by I2C1.
- Setup the Display Parallel Interface.

Signed-off-by: Alexandre Mergnat <amergnat at baylibre.com>
---
 arch/arm64/boot/dts/mediatek/mt8365-evk.dts | 236 ++++++++++++++++++++++++++++
 1 file changed, 236 insertions(+)

diff --git a/arch/arm64/boot/dts/mediatek/mt8365-evk.dts b/arch/arm64/boot/dts/mediatek/mt8365-evk.dts
index 50cbaefa1a99..6e972e2c1586 100644
--- a/arch/arm64/boot/dts/mediatek/mt8365-evk.dts
+++ b/arch/arm64/boot/dts/mediatek/mt8365-evk.dts
@@ -26,6 +26,21 @@ chosen {
 		stdout-path = "serial0:921600n8";
 	};
 
+	connector {
+		compatible = "hdmi-connector";
+		label = "hdmi";
+		type = "d";
+
+		port {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			hdmi_connector_in: endpoint at 0 {
+				reg = <0>;
+				remote-endpoint = <&hdmi_connector_out>;
+			};
+		};
+	};
+
 	firmware {
 		optee {
 			compatible = "linaro,optee-tz";
@@ -86,6 +101,15 @@ optee_reserved: optee at 43200000 {
 			reg = <0 0x43200000 0 0x00c00000>;
 		};
 	};
+
+	vsys_lcm_reg: regulator-vsys-lcm {
+		compatible = "regulator-fixed";
+		enable-active-high;
+		gpio = <&pio 129 GPIO_ACTIVE_HIGH>;
+		regulator-max-microvolt = <5000000>;
+		regulator-min-microvolt = <5000000>;
+		regulator-name = "vsys_lcm";
+	};
 };
 
 &cpu0 {
@@ -108,6 +132,89 @@ &cpu3 {
 	sram-supply = <&mt6357_vsram_proc_reg>;
 };
 
+&dither0_out {
+	remote-endpoint = <&dsi0_in>;
+};
+
+&dpi0 {
+	pinctrl-0 = <&dpi_default_pins>;
+	pinctrl-1 = <&dpi_idle_pins>;
+	pinctrl-names = "default", "sleep";
+	status = "okay";
+	ports {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		port at 0 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			reg = <0>;
+			dpi0_in: endpoint at 1 {
+				reg = <1>;
+				remote-endpoint = <&rdma1_out>;
+			};
+		};
+
+		port at 1 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			reg = <1>;
+			dpi0_out: endpoint at 1 {
+				reg = <1>;
+				remote-endpoint = <&it66121_in>;
+			};
+		};
+	};
+};
+
+&dsi0 {
+	#address-cells = <1>;
+	#size-cells = <0>;
+	status = "okay";
+
+	panel at 0 {
+		compatible = "startek,kd070fhfid015";
+		reg = <0>;
+		enable-gpios = <&pio 67 GPIO_ACTIVE_HIGH>;
+		reset-gpios = <&pio 20 GPIO_ACTIVE_HIGH>;
+		iovcc-supply = <&mt6357_vsim1_reg>;
+		power-supply = <&vsys_lcm_reg>;
+
+		port {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			panel_in: endpoint at 0 {
+				reg = <0>;
+				remote-endpoint = <&dsi0_out>;
+			};
+		};
+	};
+	ports {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		port at 0 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			reg = <0>;
+			dsi0_in: endpoint at 0 {
+				reg = <0>;
+				remote-endpoint = <&dither0_out>;
+			};
+		};
+
+		port at 1 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			reg = <1>;
+			dsi0_out: endpoint at 0 {
+				reg = <0>;
+				remote-endpoint = <&panel_in>;
+			};
+		};
+	};
+};
+
 &ethernet {
 	pinctrl-0 = <&ethernet_pins>;
 	pinctrl-names = "default";
@@ -138,6 +245,56 @@ &i2c0 {
 	status = "okay";
 };
 
+&i2c1 {
+	#address-cells = <1>;
+	#size-cells = <0>;
+	clock-div = <2>;
+	clock-frequency = <100000>;
+	pinctrl-0 = <&i2c1_pins>;
+	pinctrl-names = "default";
+	status = "okay";
+
+	it66121_hdmi: hdmi at 4c {
+		#sound-dai-cells = <0>;
+		compatible = "ite,it66121";
+		interrupt-parent = <&pio>;
+		interrupts = <68 IRQ_TYPE_LEVEL_LOW>;
+		pinctrl-0 = <&ite_pins>;
+		pinctrl-names = "default";
+		reg = <0x4c>;
+		reset-gpios = <&pio 69 GPIO_ACTIVE_LOW>;
+		vcn18-supply = <&mt6357_vsim2_reg>;
+		vcn33-supply = <&mt6357_vibr_reg>;
+		vrf12-supply = <&mt6357_vrf12_reg>;
+
+		ports {
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			port at 0 {
+				#address-cells = <1>;
+				#size-cells = <0>;
+				reg = <0>;
+				it66121_in: endpoint at 0 {
+					reg = <0>;
+					bus-width = <12>;
+					remote-endpoint = <&dpi0_out>;
+				};
+			};
+
+			port at 1 {
+				#address-cells = <1>;
+				#size-cells = <0>;
+				reg = <1>;
+				hdmi_connector_out: endpoint at 0 {
+					reg = <0>;
+					remote-endpoint = <&hdmi_connector_in>;
+				};
+			};
+		};
+	};
+};
+
 &mmc0 {
 	assigned-clock-parents = <&topckgen CLK_TOP_MSDCPLL>;
 	assigned-clocks = <&topckgen CLK_TOP_MSDC50_0_SEL>;
@@ -180,7 +337,55 @@ &mt6357_pmic {
 	#interrupt-cells = <2>;
 };
 
+&mt6357_vsim1_reg {
+	regulator-min-microvolt = <1800000>;
+	regulator-max-microvolt = <1800000>;
+};
+
 &pio {
+	dpi_default_pins: dpi-default-pins {
+		pins {
+			pinmux = <MT8365_PIN_0_GPIO0__FUNC_DPI_D0>,
+				 <MT8365_PIN_1_GPIO1__FUNC_DPI_D1>,
+				 <MT8365_PIN_2_GPIO2__FUNC_DPI_D2>,
+				 <MT8365_PIN_3_GPIO3__FUNC_DPI_D3>,
+				 <MT8365_PIN_4_GPIO4__FUNC_DPI_D4>,
+				 <MT8365_PIN_5_GPIO5__FUNC_DPI_D5>,
+				 <MT8365_PIN_6_GPIO6__FUNC_DPI_D6>,
+				 <MT8365_PIN_7_GPIO7__FUNC_DPI_D7>,
+				 <MT8365_PIN_8_GPIO8__FUNC_DPI_D8>,
+				 <MT8365_PIN_9_GPIO9__FUNC_DPI_D9>,
+				 <MT8365_PIN_10_GPIO10__FUNC_DPI_D10>,
+				 <MT8365_PIN_11_GPIO11__FUNC_DPI_D11>,
+				 <MT8365_PIN_12_GPIO12__FUNC_DPI_DE>,
+				 <MT8365_PIN_13_GPIO13__FUNC_DPI_VSYNC>,
+				 <MT8365_PIN_14_GPIO14__FUNC_DPI_CK>,
+				 <MT8365_PIN_15_GPIO15__FUNC_DPI_HSYNC>;
+			drive-strength = <4>;
+		};
+	};
+
+	dpi_idle_pins: dpi-idle-pins {
+		pins {
+			pinmux = <MT8365_PIN_0_GPIO0__FUNC_GPIO0>,
+				 <MT8365_PIN_1_GPIO1__FUNC_GPIO1>,
+				 <MT8365_PIN_2_GPIO2__FUNC_GPIO2>,
+				 <MT8365_PIN_3_GPIO3__FUNC_GPIO3>,
+				 <MT8365_PIN_4_GPIO4__FUNC_GPIO4>,
+				 <MT8365_PIN_5_GPIO5__FUNC_GPIO5>,
+				 <MT8365_PIN_6_GPIO6__FUNC_GPIO6>,
+				 <MT8365_PIN_7_GPIO7__FUNC_GPIO7>,
+				 <MT8365_PIN_8_GPIO8__FUNC_GPIO8>,
+				 <MT8365_PIN_9_GPIO9__FUNC_GPIO9>,
+				 <MT8365_PIN_10_GPIO10__FUNC_GPIO10>,
+				 <MT8365_PIN_11_GPIO11__FUNC_GPIO11>,
+				 <MT8365_PIN_12_GPIO12__FUNC_GPIO12>,
+				 <MT8365_PIN_13_GPIO13__FUNC_GPIO13>,
+				 <MT8365_PIN_14_GPIO14__FUNC_GPIO14>,
+				 <MT8365_PIN_15_GPIO15__FUNC_GPIO15>;
+		};
+	};
+
 	ethernet_pins: ethernet-pins {
 		phy_reset_pins {
 			pinmux = <MT8365_PIN_133_TDM_TX_DATA1__FUNC_GPIO133>;
@@ -222,6 +427,33 @@ pins {
 		};
 	};
 
+	i2c1_pins: i2c1-pins {
+		pins {
+			pinmux = <MT8365_PIN_59_SDA1__FUNC_SDA1_0>,
+				 <MT8365_PIN_60_SCL1__FUNC_SCL1_0>;
+			bias-pull-up;
+		};
+	};
+
+	ite_pins: ite-pins {
+		irq_ite_pins {
+			pinmux = <MT8365_PIN_68_CMDAT0__FUNC_GPIO68>;
+			input-enable;
+			bias-pull-up;
+		};
+
+		pwr_pins {
+			pinmux = <MT8365_PIN_70_CMDAT2__FUNC_GPIO70>,
+				 <MT8365_PIN_71_CMDAT3__FUNC_GPIO71>;
+			output-high;
+		};
+
+		rst_ite_pins {
+			pinmux = <MT8365_PIN_69_CMDAT1__FUNC_GPIO69>;
+			output-high;
+		};
+	};
+
 	mmc0_default_pins: mmc0-default-pins {
 		clk-pins {
 			pinmux = <MT8365_PIN_99_MSDC0_CLK__FUNC_MSDC0_CLK>;
@@ -377,6 +609,10 @@ &pwm {
 	status = "okay";
 };
 
+&rdma1_out {
+	remote-endpoint = <&dpi0_in>;
+};
+
 &ssusb {
 	dr_mode = "otg";
 	maximum-speed = "high-speed";

-- 
2.25.1




More information about the Linux-mediatek mailing list