[PATCH] arm64: dts: mt7622: fix switch probe on bananapi-r64

[Rob Herring (Arm)]

On Thu, 16 May 2024 22:48:47 +0200, Frank Wunderlich wrote:
> From: Frank Wunderlich <frank-w at public-files.de>
> 
> After commit 868ff5f4944a
> ("net: dsa: mt7530-mdio: read PHY address of switch from device tree")
> the mt7531 switch on Bananapi-R64 was not detected.
> 
> mt7530-mdio mdio-bus:00: reset timeout
> mt7530-mdio mdio-bus:00: probe with driver mt7530-mdio failed with error -110
> 
> Fix this by adding phy address in devicetree.
> 
> Signed-off-by: Frank Wunderlich <frank-w at public-files.de>
> ---
>  arch/arm64/boot/dts/mediatek/mt7622-bananapi-bpi-r64.dts | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 


My bot found new DTB warnings on the .dts files added or changed in this
series.

Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.

If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:

  pip3 install dtschema --upgrade


New warnings running 'make CHECK_DTBS=y mediatek/mt7622-bananapi-bpi-r64.dtb' for 20240516204847.171029-1-linux at fw-web.de:

arch/arm64/boot/dts/mediatek/mt7622-bananapi-bpi-r64.dtb: switch at 1f: 'interrupts' is a dependency of 'interrupt-controller'
	from schema $id: http://devicetree.org/schemas/net/dsa/mediatek,mt7530.yaml#