[PATCH 1/2] arm64: dts: mediatek: mt7622: set PHY address of MT7531 switch to 0x1f

[Arınç ÜNAL]

On 18.03.2024 18:38, Florian Fainelli wrote:
> On 3/18/24 08:26, Arınç ÜNAL wrote:
>> On 18.03.2024 16:02, Florian Fainelli wrote:
>>>>> Can we call it a pseudo PHY to use a similar terminology as what is done through drivers/net/dsa/{bcm_sf2,b53}*?
>>>>>
>>>>> This is not a real PHY as in it has no actual transceiver/digital signal processing logic, this is a piece of logic that snoops for MDIO transactions at that specific address and lets you access the switch's internal register as if it was a MDIO device.
>>>>
>>>> I can get behind calling the switch a psuedo-PHY in the context of MDIO.
>>>> However, as described on "22.2.4.5.5 PHYAD (PHY Address)" of "22.2.4.5
>>>> Management frame structure" of the active standard IEEE Std 802.3™‐2022,
>>>> the field is called "PHY Address". The patch log doesn't give an identifier
>>>> as to what a switch is in the context of MDIO. Only that it listens on a
>>>> certain PHY address which the term complies with IEEE Std 802.3™‐2022.
>>>>
>>>> So I don't see an improvement to be made on the patch log. Feel free to
>>>> elaborate further.
>>>
>>> I would just s/PHY/MDIO bus address/ since that is simply more generic, but if it is not written as-is in the spec, then I won't fight it much more than I already did.
>>
>> I'm not sure what you're referring to by spec. Are you asking how specific
>> the name of the PHYAD field is described on the standard?
> 
> Spec = IEEE Std 802.3-2022 standard, aka the document you are quoting.

Ok. The field is referred to as "PHY Address" (capital A) in a sentence on
the standard. I interpret that as it defines the term to mention the field
in a sentence which is why I'd like to stick to it on my patch log.

Arınç