[PATCH v6 00/27] Add support for sam9x7 SoC family
Andrei.Simion at microchip.com
Andrei.Simion at microchip.com
Mon Jul 29 01:17:13 PDT 2024
On 29.07.2024 09:56, Varshini Rajendran wrote:
> This patch series adds support for the new SoC family - sam9x7.
> - The device tree, configs and drivers are added
> - Clock driver for sam9x7 is added
> - Support for basic peripherals is added
> - Target board SAM9X75 Curiosity is added
>
> Changes in v6:
> --------------
>
> - Addressed all the review comments in the patches
> - Picked up all Acked-by and Reviewed-by tags
> - Reverted the IRQ patch to that of version 3 of the same series
> - All the specific changes are captured in the corresponding patches
>
> Changes in v5:
> --------------
>
> - Addressed all the review comments in the patches
> - Picked up all Acked-by and Reviewed-by tags
> - Dropped applied patches from the series
> - Addressed the ABI breakage reported in the IRQ patch
> - All the specific changes are captured in the corresponding patches
>
> Changes in v4:
> --------------
>
> - Addressed all the review comments in the patches
> - Picked up all Acked-by and Reviewed-by tags
> - Dropped applied patches from the series
> - Added pwm node and related dt binding documentation
> - Added support for exporting some clocks to DT
> - Dropped USB related patches and changes. See NOTE.
> - All the specific changes are captured in the corresponding patches
>
> NOTE: Owing to the discussion here
> https://lore.kernel.org/linux-devicetree/CAL_JsqJ9PrX6fj-EbffeJce09MXs=B7t+KS_kOinxaRx38=WxA@mail.gmail.com/
> the USB related changes are dropped from this series in order to enable
> us to work on the mentioned issues before adding new compatibles as
> said. The issues/warnings will be addressed in subsequent patches.
> After which the USB related support for sam9x7 SoCs will be added. Hope
> this works out fine.
>
> Changes in v3:
> --------------
>
> - Fixed the DT documentation errors pointed out in v2.
> - Dropped Acked-by tag in tcb DT doc patch as it had to be adapted
> according to sam9x7 correctly.
> - Picked by the previously missed tags.
> - Dropped this patch "dt-bindings: usb: generic-ehci: Document clock-names
> property" as the warning was not found while validating DT-schema for
> at91-sam9x75_curiosity.dtb.
> - Dropped redundant words in the commit message.
> - Fixed the CHECK_DTBS warnings validated against
> at91-sam9x75_curiosity.dtb.
> - Renamed dt nodes according to naming convention.
> - Dropped unwanted status property in dts.
> - Removed nodes that are not in use from the board dts.
> - Removed spi DT doc patch from the series as it was already applied
> and a fix patch was applied subsequently. Added a patch to remove the
> compatible to adapt sam9x7.
> - Added sam9x7 compatibles in usb dt documentation.
>
>
> Changes in v2:
> --------------
>
> - Added sam9x7 specific compatibles in DT with fallbacks
> - Documented all the newly added DT compatible strings
> - Added device tree for the target board sam9x75 curiosity and
> documented the same in the DT bindings documentation
> - Removed the dt nodes that are not supported at the moment
> - Removed the configs added by previous version that are not supported
> at the moment
> - Fixed all the corrections in the commit message
> - Changed all the instances of copyright year to 2023
> - Added sam9x7 flag in PIT64B configuration
> - Moved macro definitions to header file
> - Added another divider in mck characteristics in the pmc driver
> - Fixed the memory leak in the pmc driver
> - Dropped patches that are no longer needed
> - Picked up Acked-by and Reviewed-by tags
>
>
> Hari Prasath (1):
> irqchip/atmel-aic5: Add support for sam9x7 aic
>
> Varshini Rajendran (26):
> dt-bindings: atmel-sysreg: add sam9x7
> dt-bindings: mfd: syscon: add microchip's sam9x7 sfr
> dt-bindings: atmel-ssc: add microchip,sam9x7-ssc
> dt-bindings: serial: atmel,at91-usart: add compatible for sam9x7.
> dt-bindings: microchip: atmel,at91rm9200-tcb: add sam9x7 compatible
> ARM: at91: pm: add support for sam9x7 SoC family
> ARM: at91: pm: add sam9x7 SoC init config
> ARM: at91: add support in SoC driver for new sam9x7
> dt-bindings: clocks: atmel,at91sam9x5-sckc: add sam9x7
> dt-bindings: clocks: atmel,at91rm9200-pmc: add sam9x7 clock controller
> clk: at91: clk-sam9x60-pll: re-factor to support individual core freq
> outputs
> clk: at91: sam9x7: add support for HW PLL freq dividers
> clk: at91: sama7g5: move mux table macros to header file
> dt-bindings: clock: at91: Allow PLLs to be exported and referenced in
> DT
> clk: at91: sam9x7: add sam9x7 pmc driver
> dt-bindings: interrupt-controller: Add support for sam9x7 aic
> power: reset: at91-poweroff: lookup for proper pmc dt node for sam9x7
> power: reset: at91-reset: add reset support for sam9x7 SoC
> power: reset: at91-reset: add sdhwc support for sam9x7 SoC
> dt-bindings: reset: atmel,at91sam9260-reset: add sam9x7
> dt-bindings: power: reset: atmel,sama5d2-shdwc: add sam9x7
> ARM: at91: Kconfig: add config flag for SAM9X7 SoC
> ARM: configs: at91: enable config flags for sam9x7 SoC family
> ARM: dts: at91: sam9x7: add device tree for SoC
> dt-bindings: arm: add sam9x75 curiosity board
> ARM: dts: microchip: sam9x75_curiosity: add sam9x75 curiosity board
>
> .../devicetree/bindings/arm/atmel-at91.yaml | 6 +
> .../devicetree/bindings/arm/atmel-sysregs.txt | 6 +-
> .../bindings/clock/atmel,at91rm9200-pmc.yaml | 2 +
> .../bindings/clock/atmel,at91sam9x5-sckc.yaml | 4 +-
> .../interrupt-controller/atmel,aic.yaml | 1 +
> .../devicetree/bindings/mfd/syscon.yaml | 188 +--
> .../devicetree/bindings/misc/atmel-ssc.txt | 1 +
> .../power/reset/atmel,sama5d2-shdwc.yaml | 3 +
> .../reset/atmel,at91sam9260-reset.yaml | 4 +
> .../bindings/serial/atmel,at91-usart.yaml | 9 +-
> .../soc/microchip/atmel,at91rm9200-tcb.yaml | 20 +-
> arch/arm/boot/dts/microchip/Makefile | 3 +
> .../dts/microchip/at91-sam9x75_curiosity.dts | 312 +++++
> arch/arm/boot/dts/microchip/sam9x7.dtsi | 1226 +++++++++++++++++
Hi,
Sorry for disturbing, I don't see the patch where you add arch/arm/boot/dts/microchip/sam9x7.dtsi
In linux-next this file is not applied yet:
:~$ find arch/arm/boot/dts/microchip | grep -i sam9x7.dtsi | wc -l
0
Best regards,
Andrei
> arch/arm/configs/at91_dt_defconfig | 1 +
> arch/arm/mach-at91/Kconfig | 22 +-
> arch/arm/mach-at91/Makefile | 1 +
> arch/arm/mach-at91/generic.h | 2 +
> arch/arm/mach-at91/pm.c | 29 +
> arch/arm/mach-at91/sam9x7.c | 33 +
> drivers/clk/at91/Makefile | 1 +
> drivers/clk/at91/clk-sam9x60-pll.c | 42 +-
> drivers/clk/at91/pmc.h | 18 +
> drivers/clk/at91/sam9x60.c | 7 +
> drivers/clk/at91/sam9x7.c | 946 +++++++++++++
> drivers/clk/at91/sama7g5.c | 42 +-
> drivers/irqchip/irq-atmel-aic5.c | 10 +
> drivers/power/reset/Kconfig | 4 +-
> drivers/power/reset/at91-sama5d2_shdwc.c | 1 +
> drivers/soc/atmel/soc.c | 23 +
> drivers/soc/atmel/soc.h | 9 +
> include/dt-bindings/clock/at91.h | 4 +
> 32 files changed, 2840 insertions(+), 140 deletions(-)
> create mode 100644 arch/arm/boot/dts/microchip/at91-sam9x75_curiosity.dts
> create mode 100644 arch/arm/boot/dts/microchip/sam9x7.dtsi
> create mode 100644 arch/arm/mach-at91/sam9x7.c
> create mode 100644 drivers/clk/at91/sam9x7.c
>
More information about the Linux-mediatek
mailing list