[PATCH net-next v3 6/7] net: dsa: mt7530: do not set priv->p5_interface on mt7530_setup_port5()

[Arınç ÜNAL]

Vladimir could you review this too? This is the only patch remaining
without a review or ACK.

Arınç

On 22.01.2024 08:35, Arınç ÜNAL via B4 Relay wrote:
> From: Arınç ÜNAL <arinc.unal at arinc9.com>
> 
> Running mt7530_setup_port5() from mt7530_setup() used to handle all cases
> of configuring port 5, including phylink.
> 
> Setting priv->p5_interface under mt7530_setup_port5() makes sure that
> mt7530_setup_port5() from mt753x_phylink_mac_config() won't run.
> 
> The commit ("net: dsa: mt7530: improve code path for setting up port 5")
> makes so that mt7530_setup_port5() from mt7530_setup() runs only on
> non-phylink cases.
> 
> Get rid of unnecessarily setting priv->p5_interface under
> mt7530_setup_port5() as port 5 phylink configuration will be done by
> running mt7530_setup_port5() from mt753x_phylink_mac_config() now.
> 
> Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
> ---
>   drivers/net/dsa/mt7530.c | 2 --
>   1 file changed, 2 deletions(-)
> 
> diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
> index 33c15f10de34..5394d8c6a40e 100644
> --- a/drivers/net/dsa/mt7530.c
> +++ b/drivers/net/dsa/mt7530.c
> @@ -978,8 +978,6 @@ static void mt7530_setup_port5(struct dsa_switch *ds, phy_interface_t interface)
>   	dev_dbg(ds->dev, "Setup P5, HWTRAP=0x%x, intf_sel=%s, phy-mode=%s\n",
>   		val, p5_intf_modes(priv->p5_intf_sel), phy_modes(interface));
>   
> -	priv->p5_interface = interface;
> -
>   unlock_exit:
>   	mutex_unlock(&priv->reg_mutex);
>   }
>