[PATCH net-next] net: dsa: mt7530: support OF-based registration of switch MDIO bus

[Vladimir Oltean]

On Mon, Jan 22, 2024 at 08:34:31AM +0300, Arınç ÜNAL wrote:
> Currently the MDIO bus of the switches the MT7530 DSA subdriver controls
> can only be registered as non-OF-based. Bring support for registering the
> bus OF-based.
> 
> The subdrivers that control switches [with MDIO bus] probed on OF must
> follow this logic to support all cases properly:
> 
> No switch MDIO bus defined: Populate ds->user_mii_bus, register the MDIO
> bus, set the interrupts for PHYs if "interrupt-controller" is defined at
> the switch node. This case should only be covered for the switches which
> their dt-bindings documentation didn't document the MDIO bus from the
> start. This is to keep supporting the device trees that do not describe the
> MDIO bus on the device tree but the MDIO bus is being used nonetheless.
> 
> Switch MDIO bus defined: Don't populate ds->user_mii_bus, register the MDIO
> bus, set the interrupts for PHYs if ["interrupt-controller" is defined at
> the switch node and "interrupts" is defined at the PHY nodes under the
> switch MDIO bus node].
> 
> Switch MDIO bus defined but explicitly disabled: If the device tree says
> status = "disabled" for the MDIO bus, we shouldn't need an MDIO bus at all.
> Instead, just exit as early as possible and do not call any MDIO API.
> 
> The use of ds->user_mii_bus is inappropriate when the MDIO bus of the
> switch is described on the device tree [1], which is why we don't populate
> ds->user_mii_bus in that case.
> 
> Link: https://lore.kernel.org/netdev/20231213120656.x46fyad6ls7sqyzv@skbuf/ [1]
> Suggested-by: David Bauer <mail at david-bauer.net>
> Signed-off-by: Arınç ÜNAL <arinc.unal at arinc9.com>
> ---

Reviewed-by: Vladimir Oltean <olteanv at gmail.com>