[PATCH v3 3/4] media: mediatek: add MT8188 AIE driver

[CK Hu (胡俊光)]

On Wed, 2024-12-25 at 17:00 +0800, bo.kong wrote:
> From: Bo Kong <Bo.Kong at mediatek.com>
> 
> Add a V4L2 sub-device driver for MT8188 AIE.
> 
> Signed-off-by: Bo Kong <Bo.Kong at mediatek.com>
> ---

[snip]

> +static void aie_reset_output_buf(struct mtk_aie_dev *fd,
> +				 struct aie_enq_info *aie_cfg)
> +{

Why clear output buffer?
Could you point out which place in the output buffer that hardware does not write data into but software would read it?

Regards,
CK

> +	if (aie_cfg->sel_mode == FDMODE) {
> +		memset(fd->rs_output_hw.va, 0, fd->rs_output_hw.size);
> +		memset(fd->dma_para->fd_out_hw_va[RPN0_LOOP_NUM][0], 0,
> +		       RESULT_SIZE);
> +		memset(fd->dma_para->fd_out_hw_va[RPN1_LOOP_NUM][0], 0,
> +		       RESULT_SIZE);
> +		memset(fd->dma_para->fd_out_hw_va[RPN2_LOOP_NUM][0], 0,
> +		       RESULT_SIZE);
> +	} else if (aie_cfg->sel_mode == ATTRIBUTEMODE) {
> +		memset(fd->base_para->rs_pym_rst_va[0][0], 0,
> +		       fd->rs_pym_out_size[0]);
> +		memset(fd->base_para->rs_pym_rst_va[0][1], 0,
> +		       fd->rs_pym_out_size[0]);
> +		memset(fd->base_para->rs_pym_rst_va[0][2], 0,
> +		       fd->rs_pym_out_size[0]);
> +	} else if (aie_cfg->sel_mode == FLDMODE) {
> +		if (fd->variant->fld_enable)
> +			memset(fd->fld_para->fld_output_va[0], 0,
> +			       FLD_MAX_FRAME * FLD_OUTPUT_SIZE);
> +	}
> +}
> +