[PATCH v3 2/7] mailbox: mtk-cmdq: Add driver data to support for MT8196
Jason-JH.Lin
jason-jh.lin at mediatek.com
Thu Dec 19 09:07:55 PST 2024
MT8196 has 3 new hardware configuration compared with the previous SoC,
which correspond to the 3 new driver data:
1. mminfra_offset: For GCE data plane control
Since GCE has been moved into mminfra, GCE needs to append the
mminfra offset to the DRAM address when accessing the DRAM.
2. gce_vm: For GCE hardware virtualization
Currently, the first version of the mt8196 mailbox controller only
requires setting the VM-related registers to enable the permissions
of a host VM.
3. dma_mask_bit: For dma address bit control
In order to avoid the hardware limitations of MT8196 accessing DRAM,
GCE needs to configure the DMA address to be less than 35 bits.
Signed-off-by: Jason-JH.Lin <jason-jh.lin at mediatek.com>
---
drivers/mailbox/mtk-cmdq-mailbox.c | 90 +++++++++++++++++++++---
include/linux/mailbox/mtk-cmdq-mailbox.h | 2 +
2 files changed, 84 insertions(+), 8 deletions(-)
diff --git a/drivers/mailbox/mtk-cmdq-mailbox.c b/drivers/mailbox/mtk-cmdq-mailbox.c
index d186865b8dce..442ccd332d5f 100644
--- a/drivers/mailbox/mtk-cmdq-mailbox.c
+++ b/drivers/mailbox/mtk-cmdq-mailbox.c
@@ -43,6 +43,17 @@
#define GCE_CTRL_BY_SW GENMASK(2, 0)
#define GCE_DDR_EN GENMASK(18, 16)
+#define GCE_VM_ID_MAP0 0x5018
+#define GCE_VM_MAP0_ALL_HOST GENMASK(29, 0)
+#define GCE_VM_ID_MAP1 0x501c
+#define GCE_VM_MAP1_ALL_HOST GENMASK(29, 0)
+#define GCE_VM_ID_MAP2 0x5020
+#define GCE_VM_MAP2_ALL_HOST GENMASK(29, 0)
+#define GCE_VM_ID_MAP3 0x5024
+#define GCE_VM_MAP3_ALL_HOST GENMASK(5, 0)
+#define GCE_VM_CPR_GSIZE 0x50c4
+#define GCE_VM_CPR_GSIZE_HSOT GENMASK(3, 0)
+
#define CMDQ_THR_ACTIVE_SLOT_CYCLES 0x3200
#define CMDQ_THR_ENABLED 0x1
#define CMDQ_THR_DISABLED 0x0
@@ -87,11 +98,24 @@ struct cmdq {
struct gce_plat {
u32 thread_nr;
u8 shift;
+ dma_addr_t mminfra_offset;
bool control_by_sw;
bool sw_ddr_en;
+ bool gce_vm;
+ u32 dma_mask_bit;
u32 gce_num;
};
+static inline u32 cmdq_reg_shift_addr(u32 addr, const struct gce_plat *pdata)
+{
+ return ((addr + pdata->mminfra_offset) >> pdata->shift);
+}
+
+static inline u32 cmdq_reg_revert_addr(u32 addr, const struct gce_plat *pdata)
+{
+ return ((addr << pdata->shift) - pdata->mminfra_offset);
+}
+
static void cmdq_sw_ddr_enable(struct cmdq *cmdq, bool enable)
{
WARN_ON(clk_bulk_enable(cmdq->pdata->gce_num, cmdq->clocks));
@@ -112,6 +136,30 @@ u8 cmdq_get_shift_pa(struct mbox_chan *chan)
}
EXPORT_SYMBOL(cmdq_get_shift_pa);
+dma_addr_t cmdq_get_offset_pa(struct mbox_chan *chan)
+{
+ struct cmdq *cmdq = container_of(chan->mbox, struct cmdq, mbox);
+
+ return cmdq->pdata->mminfra_offset;
+}
+EXPORT_SYMBOL(cmdq_get_offset_pa);
+
+bool cmdq_addr_need_offset(struct mbox_chan *chan, dma_addr_t addr)
+{
+ struct cmdq *cmdq = container_of(chan->mbox, struct cmdq, mbox);
+
+ if (cmdq->pdata->mminfra_offset == 0)
+ return false;
+
+ /*
+ * mminfra will recognize the addr that greater than the mminfra_offset
+ * as a transaction to DRAM.
+ * So the caller needs to append mminfra_offset for the true case.
+ */
+ return (addr >= cmdq->pdata->mminfra_offset);
+}
+EXPORT_SYMBOL(cmdq_addr_need_offset);
+
static int cmdq_thread_suspend(struct cmdq *cmdq, struct cmdq_thread *thread)
{
u32 status;
@@ -143,6 +191,17 @@ static void cmdq_init(struct cmdq *cmdq)
u32 gctl_regval = 0;
WARN_ON(clk_bulk_enable(cmdq->pdata->gce_num, cmdq->clocks));
+
+ if (cmdq->pdata->gce_vm) {
+ /* config cpr size for host vm */
+ writel(GCE_VM_CPR_GSIZE_HSOT, cmdq->base + GCE_VM_CPR_GSIZE);
+ /* config CPR_GSIZE before setting VM_ID_MAP to avoid data leakage */
+ writel(GCE_VM_MAP0_ALL_HOST, cmdq->base + GCE_VM_ID_MAP0);
+ writel(GCE_VM_MAP1_ALL_HOST, cmdq->base + GCE_VM_ID_MAP1);
+ writel(GCE_VM_MAP2_ALL_HOST, cmdq->base + GCE_VM_ID_MAP2);
+ writel(GCE_VM_MAP3_ALL_HOST, cmdq->base + GCE_VM_ID_MAP3);
+ }
+
if (cmdq->pdata->control_by_sw)
gctl_regval = GCE_CTRL_BY_SW;
if (cmdq->pdata->sw_ddr_en)
@@ -199,7 +258,7 @@ static void cmdq_task_insert_into_thread(struct cmdq_task *task)
prev_task->pkt->cmd_buf_size, DMA_TO_DEVICE);
prev_task_base[CMDQ_NUM_CMD(prev_task->pkt) - 1] =
(u64)CMDQ_JUMP_BY_PA << 32 |
- (task->pa_base >> task->cmdq->pdata->shift);
+ cmdq_reg_shift_addr(task->pa_base, task->cmdq->pdata);
dma_sync_single_for_device(dev, prev_task->pa_base,
prev_task->pkt->cmd_buf_size, DMA_TO_DEVICE);
@@ -264,7 +323,7 @@ static void cmdq_thread_irq_handler(struct cmdq *cmdq,
else
return;
- curr_pa = readl(thread->base + CMDQ_THR_CURR_ADDR) << cmdq->pdata->shift;
+ curr_pa = cmdq_reg_shift_addr(readl(thread->base + CMDQ_THR_CURR_ADDR), cmdq->pdata);
list_for_each_entry_safe(task, tmp, &thread->task_busy_list,
list_entry) {
@@ -416,9 +475,9 @@ static int cmdq_mbox_send_data(struct mbox_chan *chan, void *data)
*/
WARN_ON(cmdq_thread_reset(cmdq, thread) < 0);
- writel(task->pa_base >> cmdq->pdata->shift,
+ writel(cmdq_reg_shift_addr(task->pa_base, cmdq->pdata),
thread->base + CMDQ_THR_CURR_ADDR);
- writel((task->pa_base + pkt->cmd_buf_size) >> cmdq->pdata->shift,
+ writel(cmdq_reg_shift_addr(task->pa_base + pkt->cmd_buf_size, cmdq->pdata),
thread->base + CMDQ_THR_END_ADDR);
writel(thread->priority, thread->base + CMDQ_THR_PRIORITY);
@@ -426,10 +485,10 @@ static int cmdq_mbox_send_data(struct mbox_chan *chan, void *data)
writel(CMDQ_THR_ENABLED, thread->base + CMDQ_THR_ENABLE_TASK);
} else {
WARN_ON(cmdq_thread_suspend(cmdq, thread) < 0);
- curr_pa = readl(thread->base + CMDQ_THR_CURR_ADDR) <<
- cmdq->pdata->shift;
- end_pa = readl(thread->base + CMDQ_THR_END_ADDR) <<
- cmdq->pdata->shift;
+ curr_pa = cmdq_reg_revert_addr(readl(thread->base + CMDQ_THR_CURR_ADDR),
+ cmdq->pdata);
+ end_pa = cmdq_reg_revert_addr(readl(thread->base + CMDQ_THR_END_ADDR),
+ cmdq->pdata);
/* check boundary */
if (curr_pa == end_pa - CMDQ_INST_SIZE ||
curr_pa == end_pa) {
@@ -663,6 +722,9 @@ static int cmdq_probe(struct platform_device *pdev)
if (err)
return err;
+ if (cmdq->pdata->dma_mask_bit)
+ dma_set_coherent_mask(dev, DMA_BIT_MASK(cmdq->pdata->dma_mask_bit));
+
cmdq->mbox.dev = dev;
cmdq->mbox.chans = devm_kcalloc(dev, cmdq->pdata->thread_nr,
sizeof(*cmdq->mbox.chans), GFP_KERNEL);
@@ -782,6 +844,17 @@ static const struct gce_plat gce_plat_mt8195 = {
.gce_num = 2
};
+static const struct gce_plat gce_plat_mt8196 = {
+ .thread_nr = 32,
+ .shift = 3,
+ .mminfra_offset = 0x80000000, /* 2GB */
+ .control_by_sw = true,
+ .sw_ddr_en = true,
+ .gce_vm = true,
+ .dma_mask_bit = 35,
+ .gce_num = 2
+};
+
static const struct of_device_id cmdq_of_ids[] = {
{.compatible = "mediatek,mt6779-gce", .data = (void *)&gce_plat_mt6779},
{.compatible = "mediatek,mt8173-gce", .data = (void *)&gce_plat_mt8173},
@@ -790,6 +863,7 @@ static const struct of_device_id cmdq_of_ids[] = {
{.compatible = "mediatek,mt8188-gce", .data = (void *)&gce_plat_mt8188},
{.compatible = "mediatek,mt8192-gce", .data = (void *)&gce_plat_mt8192},
{.compatible = "mediatek,mt8195-gce", .data = (void *)&gce_plat_mt8195},
+ {.compatible = "mediatek,mt8196-gce", .data = (void *)&gce_plat_mt8196},
{}
};
MODULE_DEVICE_TABLE(of, cmdq_of_ids);
diff --git a/include/linux/mailbox/mtk-cmdq-mailbox.h b/include/linux/mailbox/mtk-cmdq-mailbox.h
index a8f0070c7aa9..79398bf95f8d 100644
--- a/include/linux/mailbox/mtk-cmdq-mailbox.h
+++ b/include/linux/mailbox/mtk-cmdq-mailbox.h
@@ -79,5 +79,7 @@ struct cmdq_pkt {
};
u8 cmdq_get_shift_pa(struct mbox_chan *chan);
+dma_addr_t cmdq_get_offset_pa(struct mbox_chan *chan);
+bool cmdq_addr_need_offset(struct mbox_chan *chan, dma_addr_t addr);
#endif /* __MTK_CMDQ_MAILBOX_H__ */
--
2.43.0
More information about the Linux-mediatek
mailing list