[PATCH] Bluetooth: btusb: mediatek: Add usb reset for firmware setup failure

[Luiz Augusto von Dentz]

Hi,

On Fri, Apr 12, 2024 at 4:43 AM Hao Qin <hao.qin at mediatek.com> wrote:
>
> Add usb reset to recover BT device from a firmware setup failure,
> it will restore the device to its original state and attempt setup
> firmware again.
>
> Signed-off-by: Hao Qin <hao.qin at mediatek.com>
> ---
>  drivers/bluetooth/btusb.c | 3 +++
>  1 file changed, 3 insertions(+)
>
> diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
> index 4c0cc13adb47..c5aab361795e 100644
> --- a/drivers/bluetooth/btusb.c
> +++ b/drivers/bluetooth/btusb.c
> @@ -3160,6 +3160,9 @@ static int btusb_mtk_setup(struct hci_dev *hdev)
>                                                 btusb_mtk_hci_wmt_sync);
>                 if (err < 0) {
>                         bt_dev_err(hdev, "Failed to set up firmware (%d)", err);
> +                       btusb_stop_traffic(data);
> +                       usb_kill_anchored_urbs(&data->tx_anchor);
> +                       usb_queue_reset_device(data->intf);

What if this was already caused by a reset? Wouldn't that create a
loop resetting the device over and over again?

>                         return err;
>                 }
>
> --
> 2.18.0
>


-- 
Luiz Augusto von Dentz