[RESEND PATCH v2] media: mtk-jpeg: Fix use after free bug due to uncanceled work

[Dmitry Osipenko]

On 8/31/23 11:18, Zheng Hacker wrote:
>> The v4l2_m2m_ctx_release() already should wait for the job_timeout_work
>> completion or for the interrupt fire. Apparently it doesn't work in
>> yours case. You'll need to debug why v4l job or job_timeout_work is
>> running after v4l2_m2m_ctx_release(), it shouldn't happen.
>>
> Yes, v4l2_m2m_cancel_job waits for m2m_ctx->job_flags to be  ~TRANS_RUNNING,
> the mtk_jpeg_job_timeout_work will finally invoke v4l2_m2m_job_finish
> to trigger that.
> 
> However, this is not the only path to call v4l2_m2m_job_finish. Here
> is a invoking chain:
> v4l_streamon
>   ->v4l2_m2m_ioctl_streamon
>     ->v4l2_m2m_streamon
>       ->v4l2_m2m_try_schedule
>         ->v4l2_m2m_try_run
>           ->mtk_jpeg_dec_device_run
>             ->schedule_delayed_work(&jpeg->job_timeout_work...
>             ->error path goto dec_end
>             ->v4l2_m2m_job_finish
> 
> In some specific situation, it starts the worker and also calls
> v4l2_m2m_job_finish, which might
> make v4l2_m2m_cancel_job continues.

Then the error path should cancel the job_timeout_work, or better job
needs to be run after the dec/enc has been started and not before.

Looking further at the code, I'm confused by this hunk:

	mtk_jpeg_dec_start(comp_jpeg[hw_id]->reg_base);
	v4l2_m2m_job_finish(jpeg->m2m_dev, ctx->fh.m2m_ctx);

The job should be marked as finished when h/w has finished processing
the job and not right after the job has been started. So the job is
always completed and mtk_jpeg_job_timeout_work() doesn't work as
expected, am I missing something?

-- 
Best regards,
Dmitry