[PATCH v2] mailbox: remove runtime GCE clk control

AngeloGioacchino Del Regno angelogioacchino.delregno at collabora.com
Tue Oct 10 04:52:03 PDT 2023


Il 06/10/23 11:15, Jason-JH Lin (林睿祥) ha scritto:
> Hi Angelo,
> 
> Thanks for the reviews.
> 
> On Wed, 2023-10-04 at 11:20 +0200, AngeloGioacchino Del Regno wrote:
>> Il 04/10/23 10:54, Jason-JH.Lin ha scritto:
>>> 1. GCE is a frequently used module, so runtime controlling
>>> GCE clock won't save too much power and its original design
>>> doesn't expect it to be enabled and disabled too frequently.
>>>
>>> 2. Runtime controlling GCE clock will cause display HW register
>>> configured in worng stream done event issue below:
>>>     GCE should config HW in every vblanking duration.
>>>     The stream done event is the start signal of vblanking.
>>>
>>>     If stream done event is sent between GCE clk_disable
>>>     and clk_enable. After GCE clk_enable the stream done event
>>>     may not appear immediately and have about 3us delay.
>>>
>>>     Normal case:
>>>     clk_disable -> get EventA -> clk_enable -> clear EventA
>>>     -> wait EventB -> get EventB -> config HW
>>>
>>>     Abnormal case:
>>>     clk_disable -> get EventA -> clk_enable -> EventA delay appear
>>>     -> clear EventA fail -> wait EventB but get EventA -> config HW
>>>
>>> So just remove the runtime GCE clock contorl.
>>>
>>> Signed-off-by: Jason-JH.Lin <jason-jh.lin at mediatek.com>
>>
>> Instead of entirely removing the logic that controls the clocks and
>> always
>> refuse to save power, what about using autosuspend?
>>
>> If the two cases that you're describing are happening always in a
>> range of
>> time, we could *yes* remove the "manual" bulk disable/enable calls,
>> but then
>> we could use runtime_suspend/runtime_resume callbacks for that.
>>
>> Hint: pm_runtime_set_autosuspend_delay(dev, 1000);
>>
>> Regards,
>> Angelo
>>
> 
> These 2 issues are caused by GCE bulk_clk enable/disable too
> frequently.
> 
> As I now, pm_runtime_set_autosuspend_delay() is for controlling the
> power domain. The power domain of GCE is infrasys which can only be
> enabled/disabled by spm during the whole system resume/suspend.
> So I'm not sure about how can pm_runtime_set_autosuspend_delay() save
> power for GCE bulk_clk in this case.
> 
> Could you give more hint for me please?
> 

I think it's faster if I send my own version of that, I'm testing that right now
on multiple Chromebooks to check if this solves the issue that you're describing,
which I believe it to be the "apparent random lockups" or display stuttering when
in a high load situation.

I don't seem to get any more stuttering nor apparent random lockups on a MT8195
Chromebook, and that's with my pm_runtime autosuspend solution, with a runtime
suspend delay of 100ms, which I'm trying to decrease as much as possible in order
to keep saving as much power as possible.

For this, if you could better describe how to reliably reproduce the issue that
you have described, it would help me a bit in making this as good as possible.

Thanks,
Angelo




More information about the Linux-mediatek mailing list