[PATCH net-next v2 4/6] net: mdio: scan bus based on bus capabilities for C22 and C45

[Klaus Kudielka]

On Sat, 2023-03-11 at 16:39 +0100, Andrew Lunn wrote:
> 
> I have one more idea which can speed things up. The scanning of the
> MDIO bus works in two different ways depending on if there is a DT
> node, describing what should be found on the bus. For mv88e6xxx, using
> DT is optional. Some boards do, some don't.
> 
> If there is a DT node, only the addresses listed in DT are scanned.

Here's the definition of the switch in the Turris Omnia device tree.

	/* Switch MV88E6176 at address 0x10 */
	switch at 10 {
		pinctrl-names = "default";
		pinctrl-0 = <&swint_pins>;
		compatible = "marvell,mv88e6085";
		#address-cells = <1>;
		#size-cells = <0>;

		dsa,member = <0 0>;
		reg = <0x10>;

		interrupt-parent = <&gpio1>;
		interrupts = <13 IRQ_TYPE_LEVEL_LOW>;

		ports {
			#address-cells = <1>;
			#size-cells = <0>;

			ports at 0 {
				reg = <0>;
				label = "lan0";
			};

			ports at 1 {
				reg = <1>;
				label = "lan1";
			};

			ports at 2 {
				reg = <2>;
				label = "lan2";
			};

			ports at 3 {
				reg = <3>;
				label = "lan3";
			};

			ports at 4 {
				reg = <4>;
				label = "lan4";
			};

			ports at 5 {
				reg = <5>;
				label = "cpu";
				ethernet = <&eth1>;
				phy-mode = "rgmii-id";

				fixed-link {
					speed = <1000>;
					full-duplex;
				};
			};

			ports at 6 {
				reg = <6>;
				label = "cpu";
				ethernet = <&eth0>;
				phy-mode = "rgmii-id";

				fixed-link {
					speed = <1000>;
					full-duplex;
				};
			};
		};

> 
> If there is no DT node, by default, all 32 addresses on the bus are
> scanned. However, DSA makes another assumption. There is a one to one
> mapping between port number and PHY address on the MDIO bus. Port 0
> uses MDIO address 0. Port 7 uses MDIO address 7 etc. If you have an 8
> port switch, there is no point scanning addresses 8 to 31, they will
> never be used.
> 
> The mdio bus structure has a member phy_mask. This is a bitmap. If bit
> N is set, address N is not scanned. So i suggest you extend
> mv88e6xxx_mdio_register() to set phy_mask based on
> mv88e6xxx_num_ports(chip).
> 

What you are proposing here would not show any improvement on the
Omnia, as only the 6 ports would be scanned - right? 

>         Andrew