[PATCH 2/2] mips: pci-mt7620: use dev_info() to log PCIe device detection result

[Shiji Yang]

Usually, We only need to print the error log when there is a PCIe card but
initialization fails. Whether the driver finds the PCIe card or not is the
expected behavior. So it's better to log these information with dev_info().

Tested on MT7628AN router Motorola MWR03.

Signed-off-by: Shiji Yang <yangshiji66 at outlook.com>
---
 arch/mips/pci/pci-mt7620.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/mips/pci/pci-mt7620.c b/arch/mips/pci/pci-mt7620.c
index df3347643..5c4bdf691 100644
--- a/arch/mips/pci/pci-mt7620.c
+++ b/arch/mips/pci/pci-mt7620.c
@@ -327,7 +327,7 @@ static int mt7620_pci_probe(struct platform_device *pdev)
 		rt_sysc_m32(RALINK_PCIE0_CLK_EN, 0, RALINK_CLKCFG1);
 		if (ralink_soc == MT762X_SOC_MT7620A)
 			rt_sysc_m32(LC_CKDRVPD, PDRV_SW_SET, PPLL_DRV);
-		dev_err(&pdev->dev, "PCIE0 no card, disable it(RST&CLK)\n");
+		dev_info(&pdev->dev, "PCIE0 no card, disable it(RST&CLK)\n");
 		return -1;
 	}
 
@@ -370,7 +370,7 @@ int pcibios_map_irq(const struct pci_dev *dev, u8 slot, u8 pin)
 			dev->bus->number, slot);
 		return 0;
 	}
-	dev_err(&dev->dev, "card - bus=0x%x, slot = 0x%x irq=%d\n",
+	dev_info(&dev->dev, "card - bus=0x%x, slot = 0x%x irq=%d\n",
 		dev->bus->number, slot, irq);
 
 	/* configure the cache line size to 0x14 */
-- 
2.30.2