[PATCH RFC net-next 08/15] net: mvneta: update PCS driver to use neg_mode

Russell King (Oracle) rmk+kernel at armlinux.org.uk
Tue Jun 13 07:38:08 PDT 2023


Update mvneta's embedded PCS driver to use neg_mode rather than the
mode argument. As there is no pcs_link_up() method, this only affects
the pcs_config() method.

Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 drivers/net/ethernet/marvell/mvneta.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/marvell/mvneta.c b/drivers/net/ethernet/marvell/mvneta.c
index e2abc00d0472..ff5647bcdfca 100644
--- a/drivers/net/ethernet/marvell/mvneta.c
+++ b/drivers/net/ethernet/marvell/mvneta.c
@@ -4002,8 +4002,8 @@ static void mvneta_pcs_get_state(struct phylink_pcs *pcs,
 		state->pause |= MLO_PAUSE_TX;
 }
 
-static int mvneta_pcs_config(struct phylink_pcs *pcs,
-			     unsigned int mode, phy_interface_t interface,
+static int mvneta_pcs_config(struct phylink_pcs *pcs, unsigned int neg_mode,
+			     phy_interface_t interface,
 			     const unsigned long *advertising,
 			     bool permit_pause_to_mac)
 {
@@ -4016,7 +4016,7 @@ static int mvneta_pcs_config(struct phylink_pcs *pcs,
 	       MVNETA_GMAC_AN_FLOW_CTRL_EN |
 	       MVNETA_GMAC_AN_DUPLEX_EN;
 
-	if (phylink_autoneg_inband(mode)) {
+	if (neg_mode == PHYLINK_PCS_NEG_INBAND_ENABLED) {
 		mask |= MVNETA_GMAC_CONFIG_MII_SPEED |
 			MVNETA_GMAC_CONFIG_GMII_SPEED |
 			MVNETA_GMAC_CONFIG_FULL_DUPLEX;
@@ -5518,6 +5518,7 @@ static int mvneta_probe(struct platform_device *pdev)
 		clk_prepare_enable(pp->clk_bus);
 
 	pp->phylink_pcs.ops = &mvneta_phylink_pcs_ops;
+	pp->phylink_pcs.neg_mode = true;
 
 	pp->phylink_config.dev = &dev->dev;
 	pp->phylink_config.type = PHYLINK_NETDEV;
-- 
2.30.2




More information about the Linux-mediatek mailing list